Full Product Manual

28
Maintenance
SPARK PLUG MAINTENANCE:
1. Remove Spark Plug Cap (refer to "Spark Plug Cap Removal” figure below.)
2. Remove Spark Plug with socket and handle supplied with your unit (refer to “Spark Plug Removal”
figure below.)
3. Cl e an an y car bon build - up ar ound th e Sp ark P lu g .
4. Ch eck th e Sp ark P lu g G ap and adjus t if n ece ss ary . 0 .3 0 - inch g ap.
5. Lub r i cate th e th re ads of th e Sp ark P lu g w ith anti - s e i ze c o m pound o r e n g in e oil.
6. Re - install th e Sp ark P lu g and Sp ark P lu g Cap.
Spark Plug Cap Removal Spark Plug Removal
FUEL SYSTEM MAINTENANCE:
NOTE: Periodically you can get sediment or trash in your Carburetor Bowl. Use the following procedures to
clean:
1. Turn the fuel cock (valve) to the “OFF” Position.
2. Remove the carburetor bowl by removing the mounting bolt located at the bottom of the bowl.
3. Dump out the old fuel and sediment into an approved container and clean carburetor bowl
thoroughly.