Instructions / Assembly

!
"#$%&!'()*+!,-%!
../0!#12345+678!'7+9!:(72!
;71!<3+*1=!%:!>.?0@!
A@@BC>DB>C@C!
)))E86F71G()*+347EH(I!
.O!
@JTOMLOJOSL&(continued)*
*
%!$'g&!"10&@$./)#/$/2#b&
1. Remove*Spark*Plug*Cap*(refer*to*"Spark*Plug*Cap*Removal”*figure*below.)*
2. Remove*Spark*Plug*with*socket*and*handle*supplied*with*your*unit*(refer*to*
“Spark*Plug*Removal”*figure*below.)*
3. Clean*any*carbon*build>up*around*the*Spark*Plug.*
4. Check*the*Spark*Plug*Gap*and*adjust*if*necessary.***0.30>inch*gap.*
5. Lubricate*the*threads*of*the*spark*plug*with*anti>seize*compound*or*engine*oil.**
6. Re>install*the*Spark*Plug*and*Spark*Plug*Cap.*
*
*
*
*
*
*
*
*
*
*******%\JQc&!ZR[&2J\&'LXUdJZ& %\JQc&!ZR[&'LXUdJZ&
*
*
+1#"&%<%)#@&@$./)#/$/2#b&
/,)#b&Periodically*you*can*get*sediment*or*trash*in*your*Carburetor*Bowl.**Use*the*
following*procedures*to*clean:*
1. Turn*the*fuel*cock*(valve)*to*the*“OFF”*Position.*
2. Remove*the*carburetor*bowl*by*removing*the*mounting*bolt*located*at*the*
bottom*of*the*bowl.*
3. Dump*out*the*old*fuel*and*sediment*into*an*approved*container*
4. Clean*carburetor*bowl*thoroughly.*
5. Fit*a*new*rubber*washer*into*place*and*re>attach*fuel*bowl*to*the*carburetor.*
/,)#b&'LXUdJZ&UK&MaL&WQJTO&PSQL]&JM&MaL&YUMMUX&UK&MaL&YU]Z&SJO&WQJTO&MaL&KRLZ&MU&
QLXUdL&PXJZZLQ&WLYQTP&MaJM&aJP&SUZZLSMLW&TO&MaL&YU]Z5&
6. After*bowl*is*securely*back*in*place,*turn*the*fuel*cock*(valve)*to*the*“ON”*
position*for*use.*
7. Units*equipped*with*a*pre>filter*for*fuel*will*have*a*filter*housed*just*below*the*
fuel*cock.**Remove*the*fuel*filter*element*(refer*to*“Fuel*Filter*Element*
Removal”)*and*clean*or*replace.**
!