Replacement Part List

11
Safety Instructions
WARNING!
While engine is running temperature may exceed 150°F (65°C). Server
burns may occur.
Exhaust heat/gasses can ignite combustibles, structures or damage fuel tank causing a fire.
 Do NOT touch hot surfaces and do avoid exhaust gases.
 Allow pressure washer to cool before touching.
 Keep at least 7 ft. (183cm) clearance on all sides of pressure washer including overhead clear.
 Reflective exhaust heat may damage fuel tank causing fire.
 Code of Federal Regulation(CFR) Title 36 Parks, Forests, and Public Property require equipment powered by an internal combustion engine to
have a spark arrester, maintained in working order, complying to USDA Forest service standard 5100 -‐‐ 1c or later revision. In the state of
California a spark arrester is required under section 4442 of the California Public resources code.
WARNING!
Unintentional sparking can result in fire or electrical
shock.
WHEN TESTING FOR ENGINE SPARK
 Do NOT check for spark with the spark plug removed.
 Use approved spark plug tester.
WHEN REPAIRING OR ADJUSTING WATER PUMP
 Disconnect the spark plug wire from the spark plug and place the wire where it cannot contact spark plug.
CAUTION!
Improper use and care of this pressure washer will cause damage and shorten its lifespan. Failure to follow these actions will void all
warranties.
 Use pressure washer only for appropriate and designated purposes.
 The dealer or customer helpline (1 -‐‐ 866 -‐‐ 471 -‐‐ 7464) can instruct you on intended uses.
 Pressure washer must be placed on a level surface.
 Do NOT expose pressure washer to extreme conditions. Excessive dust, moisture, and corrosive vapors will damage unit.
 Cooling slots must be kept clear of debris.
 Shut off pressure washer and take to a qualified service center if the pressure washer fails to operate properly.
NOTE: NEVER ALLOW PRESSURIZED WATER EXITING SPRAY GUN TO CONTACT SKIN OF HUMAN
OR ANIMAL.