Replacement Part List

Pre

Operating Instructions: Connecting Inlet/Outlet/Chemical

Injector Hose

CONNECTING CHEMICAL INJECTOR HOSE: Water to Chemical ratio is 7:1. NOTE: The Chemical

Injector Hose provided is the white/clear hose and should be

used in unison with the Spray (black)

Nozzle.

CAUTION: WHEN USING CHEMICALS OR CLEANING SOLUTIONS:



Use soaper tip only for chemicals/soap.



Use ONLY soaps and chemicals designed for pressure washer use.



Do NOT use bleach.



Ensure water to chemical ratio is 7:1.



Ensure chemicals are NOT allowed to remain in pump after use. Failure

to clean chemicals

out of pump will damage unit and void warranty.

1. Connect the Chemical Injector Hose to the Chemical Injector Connection on Pump. Tighten

Securely.

2. Place alternate end of Chemical Injector Hose into chemical/cleaning solution to be used. This

end of the Chemical Injector Hose will have a filter to keep foreign debris from entering pump.

3. After use of Chemicals/Cleaning Solutions, place the end with the filter of the

Chemical Injector

Hose in clean water and allow operating for three (3) minutes to clean excess chemicals from

pump housing.

NOTE:

als

ill

OT siphon

with high pressure wand tips, only use the black soaper low

pressure tip