Manual

620
83
620
84
USB Play
When the USB equipment is connected,
the system switches to the USB play mode
automatically, “USB” is displayed; if
the USB equipment is not connected,
“NO USB” is displayed. If there is USB
equipment connected, press SRC to
select USB play. Wh en the USB file list
is finished,the player will repeat from
the beginning automatically.
Resetting Operation
When such faults as crash, open failure,
shutdown or enter failure and disk out
occur in using, long press SEL for
more than 5s to make system enter
resetting operation.
Common Fault and Troubleshooting
CD Disk Exit
Press to get the CD disk out and it will
return to the radio or USB mode before
CD playing automatically. If the CD is not
taken out after 10s, then the disk will go
inside automatically, however, the
player will not play automatically,
SRC is to be pressed for switching
over.
●Don't leave any finger print on the disk
●After the CD exits, put it into CD case,
to avoid damage and dust taint.
●Prevent from heat or insolation
●When handing the disk, take by its central
and outer part
CD Disk Maintenance
Fault
Host machine is in
malfunction, no
display
Host machine is in
operation, but the
sound is low or there
is no sound at all.
Poor radio reception
Cause
Wrong wiring
Fuse blown
The volume is turned down too
much
Antenna is not connected properly
Troubleshooting
Correct the wiring
Repl ace a fuse of the sam e speci ficat ion
Turn up the volume
Check the antenna, and connect it well
No sound for left
and right tracks
Balance of one side is closed
Wrong cable connection
Adjust the balance/fader mode well accordingly
Correct the connection
Note
●Never take apart or refit the stereo
by yourself.
●Please adjust the sound volume to
the degree that may not disturb your
hearing the traffic signals (siren,
alarm whistle etc.).
Sound jump, poor
tonal quality
The disk can't be
taken out
Fault
Cause
Troubleshooting
Tainted or scratched disk
Defected disk or failed machine
Clean the disk
Press ( exit). If it still can not
work normally, please contact the
for repair.
Lifan service station
The needed radio
station can't be
searched
Play failure
No sound
The disk is in the
drive, but there is
no sound
Weak station signal
Tainted disk
The disk in serte d is not among
the kin ds avail able fo r pla y
Wrong connection
The disk is inserted with the
wrong side upward
Tainted or scratched disk
Switch to manual search
Clean the di sk
Check the disk kind
Check the connection
Insert the disk with the label side
upward
Clean the disk
Reverse gear indication
When CD player is on, pull the gear lever
to reverse (R), the CD player enters pause
/muse automatically, meanwhile, the
“TEL CALL” is displayed, indicating
the driver that the car is under reverse.
Instru cti on Manual of Lifan Sedan
LIFAN
Instru cti on Manual of Lifan Sedan
Instru cti on Manual of Lifan Sedan
LIFAN
Chongqing Lifan Passenger Vehicle Co., Ltd.
Chongqing Lifan Passenger Vehicle Co., Ltd.