A WARNING SPECIAL HAZARDS * CO Poisoning: Exhaust from engine contains carbon monoxide, a poisonous gas that can cause carbon monoxide poisoning and possible death inhaled. + Elocution shock: Operating equipment in wet conditions or near wale can cause election shock = Chemical Exposure: Cleaning chemical vapors or contact with skin may be hazardous.
TABLE OF CONTENTS Preface Operation of Overate caw 24 Product Specializations . «oo 7 Slog the Veil LL. Lo 0s ose 29 Safety Petitions LL LL... 8 Magdalena Controls and Fesses ovo 1" i an PREPONDERATING INSTRUCTIONS Bally oo ci eee eee ae 34 MESABI «vines Rene 18 Wattle Hast Erin Fuel Level IDOL oo cn Cannes 21 Lifted Warranty Polly . u. u. as Engine Of Lapel Cork. Loan Dvina 22 PLEASE READ THE FOLLOWING INSTRUCTIONS! 1. Unit Shipped without engine oil. See Preoperative Instructions for further information.
PREFACE Thank you for choosing LI FAN Power USA for your Power Equipment needs. LI FAN Power USA prides itself on providing quality products at affordable pricing, creating the “Best Equipment Value on Today's Market!” Your Portable Generator utilizes our Industrial Grade Gasoline Engines and is intended for OUTDOOR USE ONLY. All LI FAN Power USA products are manufactured utilizing the latest technology.
SAFETY INSTRUCTIONS This is the safety alert The safety and alert symbol Wherewithal symbol. Otis used to alert signal word (CAUTION, DANGER, WARNING), you to potential personal 2) clitoris nor safety message to alert you injury hazards, Obey all safety messages that follow this CAUTION indicates a hazard which, if not f tle fond avoided, could be harmful, or might result in Symbol fo avoid possible Injury or | Las Sade rate injury.
WwW ONLY operate generators outdoors. Exhaust gas must be prevented Running generator from entering confined areas. r emits carbon SD monoxide: an Direct exhaust gas away from odorless, colorless, windows, doors, ventilation, and poisonous gas. Wb other openings. Breathing carbon . Lo monoxide can cause Da not operate this generator inside nausea or death! or under any buildings.
WARNING A While engine is running temperature may exceed 150°F Severe burns may occur. WARNING A Unintentional sparking can result in fire or electrical shock. A CAUTION A Excessively high operating speeds {engine revolutions) increase the risk of injury and damage fo the generator. Excessively low speeds impose a heavy load and will damage generator, CAUTION! Improper use and ore of this generator will course damage and shorten Hs aspen.
CONTROLS AND FEATURES ES6600E 11200 ON/OFF AG PLUG Ji SWITCH Lh cit [rom Se i + WHEELS HANDLES {factoid diver)
CONTROLS AND FEATURES PGA37SE-CA GIO co ix 120 SWITCH WATCHDOG AG PLUG WHEELS HANDLES {Hebe dowdy
CONTROLS AND FEATURES PGB82S0E-CA ON/OFF CO THY SWITCH WATCHDOG AC PLUG SI HANDLES folded dies)
~ CONTROLS AND FEATURES ACRE ak AHN Ed a soa Fi mend BREAKER ESBT00/ESG600E aE sg wie Be soa foc HME MARION ARLENE BON
LEGEND Fuel Level Sensor Displays currant fuse loved Fuel Tank Cap Vested fue sap must be propped installed at off times during operation Receptacle Panel see product specifications for individual modal Double Pole Circuit Breaker (AC) ~ protects receptacles & generator from overload Crankcase CH Dipstick / Oi Fill Hole Cap check/Mill engine off Won J OFF Switch rocker style; set to “ON to start engine and “OFF” to shay off engine Crankiness Oil Drain Plug ~ remove to drain oil from crankcase Re coll Starti
PER-OPERATING INSTRUCTIONS WHEEL KIT ASSEMBLY FOR WHEEL BIT INSTALLATION The Following Tools are needed fo install Wheel Kits » Safely Glasses * Benin 10mm Wrench Set = S mm-13mim Weens Set * Glove Wheel Kit Installation Directions: HOT: Install Whee! Kit BEFORE Filling the Generator with Fast or OU. Never Tip a Unit that contains Fuel or Gi 1. Tip Generator so Engine End sup. 2. Place the Support Legs sender the Frame Brace, 3 Secure with the provided Cap Screws and Hex Nuts.
~~ PER-OPERATING INSTRUCTIONS BATTERY SPECIFICATIONS {Electric Start (E£) Models Only} The Battery is NOT included with your Energy Storm Generator. These units require an Acid Cell Battery. This battery is used in many applications, such as lawnmowers, ATV's, motorcycles, ele. and can be found at many retailers and dealers including where you purchased this Power Equipment Product. Use the "Battery Specifications” chart below to attain the specifications of the necessary battery.
PER-OPERATING INSTRUCTIONS: SETUP WARNING A Fuel and its vapors are extremely flammable and explosive. Fire or explosion can cause severe burns or death. WHEN ADDING FUEL Turn generator off and let it cool for a minimum of three minutes before removing fuel cap. Tara and remove cap slowly in order to relieve residual tank pressure. Always fill the fuel tank with the unit outdoors. DO NOT overfill tank. Allow room for fuel expansion.
or PER-OPERATING INSTRUCTIONS: SETUP BOX CONTENTS: » Generator . » Wheel Kit = Accessory Kit only) Spark Plug Removal Tool s Zea Never-Geo-Flat Foam Filled Wheels +1 pa, » Nematode-30 Male Twist Lock Plug Heavy Duly Ley Supports = Owner's Manuel and Warty Cad (Shipped Stored Under Peel Tank] Fea Axis Handle «» Hardware Bag RATION Ay attend to steed the generator bole BE hag bees properly seconder phooey rest In so nine allusive and volt woodland, ADD ENGINE OW: Refer to the diagram below. 1.
PER-OPERATING INSTRUCTIONS: SETUP WHEN ADDING FUEL Turn generator off and bet it cool for a minimum of three minutes before reorging fuel cag Turn and remove cap showy in order to relieve residual tank presser. Always fill the fuel dark with the unit outdoors. BO NOT overfill tank. Allow room for fuel expansion. Kerr fuel away from sparks, open Blames, heat, pilot lights, and other ignition sources, ADD FUEL: Refer to Controls and Features section Tor diagrams. 1.
OPERATING YOUR GENERATOR NGL ee Running generator emits carbon ! monoxide: an odorless, colorless, poisonous gas. Breathing carbon monoxide can cause nausea or death! A CAUTION A Never start or shut off the generator with electrical loads connected and in the operational mode. Starting or shutting off the generator with electrical loads activated may result in damage to the generator. 1.
OPERATING YOUR GENERATOR CONNECTING ELECTRICAL LOADS: 1. Ensure engine is started before plugging in any electoral appliance. 2. Plug in desired 120 Volt loads to the 120 volt Us Ground and 240 Volt loads to fhe 240 Volt receptacles on the LFBOUOE model, Always plug appliances into the generator with appliance in fs "OFF" position. 3. Do NOT connect 240 Volt loads to the 120 Volt receptacles. 4. Only connects single-phase 60 Hertz loads. £. DO NOT OVERLOAD THE GENERATOR.
NGL Le « To prevent electrical shock from faulty appliances, the generator should be grounded, Connect a length of heavy cable between the generators grounding terminal and an external ground source. * This generator is not intended, nor designed, for use as a standby power supply of to be connected to an malicious transfer switch (ATS) it should WARNING never be used as such. Severe properly damage and/or severe personal Injury or death may resell.
dor LAG L Le Only operate generator outdoors, Prevent exhaust gas Tom entering, through windows doors or ventilation intakes, any confined areas. DO NOT operate generator inside any enclosed or roofed areas. This Includes the generator compartment of say recreational vesicles [AVL Neap the generator away from other electric calicoes or wires stitch as commercial power supply treys, The DU receptacle (in the Battery Charge section of the control panel) can be ached while the 80 power Is i use.
The G0 Watchdog technology monitors the contamination of poisonous Carbon Monoxide (COy gas produced by engine exhaust when the generator is naming. C0 Watchdog detects elevated levels of CO gas, it automatically shuts off the engine. Translators are blended to be used outdoors, Tar away from occupied Buildings ard exhaust pointed away from people and buildings.
OPERATING YOUR GENERATOR TRANSFER SWITCH CONNECTIONS « Only allow Professions Electrician The Energy Storm generator Is wired with the austral bonded 0 ground, If you are connecting your generator to a transfer switch, the electrician must first determine what type transform switch is being used, Transfer switches Tor this equipment are either two-logs or the pole types, A tadpole transform switch will not switch the neutral from the generator to the service panel.
HIGH ALTITUDE KIT REPLACEMENT FOR NEPALI ENGINES A000-B0006. | B000-8000%, of elevation Ad high mudslide, he storyboard carburetor air-fuel mixture will be foo doh. Performance wilt decrease and fuel consumption will increase, Avery rich mi bare will glee foul the spark plug and cause herd starting, Operation at an allude that differs from that af which this engine was certified, for extended periods of Heine, may crankiness permissions.
STORING THE UNIT STORAGE Before long term storage of your power equipment product, typically 30 days or more, perform the following: 1. Bet the fuel cock (valve) to the “OFF” position, 2. Lest the unit contain to yun wit iE stops self, booming all of the fus! in the fue! system. 3. Turn Use ignition switch to the “OFF” position. 4. Brain the engine ofl in accordance with the "Ol Change Procedures” in this Owner's Manuals Maintenance section. Do NOT re-fill with oil unlit ready to use again, &.
ne MAINTENANCE NOTE: Refer to Following Procedures for Proper Method to Perform Maintenance MAINTENANCE SCHEDULE PROCEDURE TIME Engine Oi eck Ea se , After Each 40 Hours of use {for initial Replace Engine OF break-in after first 10 hours of use) Air Cleaner Filter Check | Each Use Air Cleaner Filter Replacement Jain Needed of After Every 50 Hours Al Cleaner Was one Needed When necessary or within 100 hours of Spark Plug run time Y bi Cla k hose oad U nu ally or after Suet Tank Replace every 3 years based on
MAINTENANCE WARNING! AVOID SPLASHING OF HOT OIL; IT CAN BURN YOU AND CAUSE SEVERE INJURY. 4, After ofl is completely drained, replace ofl drain plug and tighten with appropriate tools. Replace off with the proper olf for your product, Refer to the Pr-Operating Instruction: Generator Setup section for exact Bi requirements. Always use your dipstick to check the oil novel and only fill to the full meek on the dipstick. Ever overfill the engine as this can cause damage 10 the unit and void warranty, &.
MAINTENANCE SPARK PLUG MAINTENANCE 1. Remove Spark Log Cap refer to “Spark Plug Cap Removal” figure below} 2. Remove Spark Plug with socket and handle supplied with your unit {refer to "Spark Plug Removal” figure below) 3. Clean any carbon bullwhip around the Spark Plug. 4, Check the Spark Plug Gap and adjust i necessary. gap. 5. Lubricate the threads of the Spark Plug with anti-seize compound or engine oil, &. Reinstall the Spark Plug aod Spark Plug Cap.
TROUBLESHOOTING IF THE ENGINE WILL NOT 8TA°T 1. Check to ensure switches are in the “ON” position. {Both obit and engine} 2, Cheek engine oil level, Your unit possesses a Low Oil Alarm System that will pot allow your engine to start if the oil is below sale operating levels. This feature is Installed to increase the fife of your engine and prevent engine damage. if oll level is low, fill fo the full mark on dipstick. Refer to the Product Specifications for exact ofl type and amounts. 8.
LS LL GENERATOR SAFETY 1. Ever operate gasoline engine powered products in any enclosed spaces, as they produce deadly Carbon Monoxide Poisonous Gases, 2. Ever hook a generator directly to your home circuit without the proper installation by a Licensed Electrician and without the groper power transfer devices. 3. Do NOT operate your power equipment in inclement weather such as rain, snow, and/or steal.
WATTAGE CHART veg png a E00 Faith Ba aio a harsh 0 # irs So iin Tab o Ben Rig Heating fag ws 9 Felon Bik Bg aon i DER a 0 ae Dias Bsa LE B50 Hing Wp a0 hand a Ba ae Sask Calder Tuna Hoa i
TATTAGE CHART i aa Hw B00 Sel 120 EE Serie ita Hon Bin Ding ae ABE
CONVERTING AMPS OR HORSEPOWER INTO WATTS I necessary, use these formulas: Walls = Amps x Volts Running Walts® = Horsepower x 832% [for motors) Remember, this worksheet sits average power requirements o particular manufacturer's device may use more or less than the listed wattage. = fold & 10% correction factor to your totals to help overcome this uncertainty. I vor customer plans to operate devices they use electric motors, list both the starting grad murmuring requirements of each.
