95Ri, 93Ri, 90R Recumbent Exercise Bikes Assembly Instructions
Congratulations... and welcome to the world of The following Parts Identification Listing and the step by step assembly procedures have been assembled to make the set-up of the Recumbent Exercise Bikes as quick and easy as possible. Please take special note of the following important points prior to choosing a location and beginning assembly of the Recumbent Exercise Bikes.
IMPORTANT SAFETY INSTRUCTIONS! ⇒ DO NOT locate the Recumbent Exercise Bike outdoors, near swimming pools, or in areas of high humidity. ⇒ DO NOT operate your Recumbent Exercise Bike if it has been dropped, damaged, or even partially immersed in water. Contact Life Fitness Customer Support Services at the number in the Operation Manual. ⇒ DO NOT locate the Recumbent Exercise Bike any closer than 30 inches (76 cm) to a television set.
TOOLS REQUIRED FOR ASSEMBLY...
Please read this prior to assembly. This product is preconfigured to accept the addition of the Life Fitness Entertainment System. A POWER CABLE and COAXIAL CABLE have been pre-installed. Please read both the product assembly instructions and Entertainment Ready assembly instructions (included with the Life Fitness Entertainment System) prior to assembly. Route the POWER CABLE and COAXIAL CABLE alongside the MAIN WIRE HARNESS where applicable.
1. 2. Slide the ACCESSORY TRAY (#8) (if so equipped) over the user right seat back post and down to make contact with the SEAT HANDLEBAR. Position the underside clamp bracket (A) around the SEAT HANDLEBAR and tighten the two clamp SCREWS and WASHERS (B). NOTE: BE CAREFUL NOT TO OVER-TIGHTEN THE SCREWS. 3. MISE EN GARDE : VEILLER À NE PAS TROP SERRER LA VIS. Align the four holes in the SEAT BACK (#5) with those in the SEAT BACK POSTS.
9. After placing the exercise bike in the intended location for use, check the stability of the bike. If the exercise bike is not level, turn a LEVELER (G) in the rear STABILIZER BAR (H) in either direction until the rocking motion is eliminated. Tighten the JAM NUT (J) when the exercise bike is level. H NOTE: ONLY ONE LEVELER NEEDS TO BE TURNED. REMARQUE : NE TOURNER QU’UN SEUL VÉRIN. 10. Locate the RIGHT PEDAL STRAP (#10) marked with an “R”.
PRE-OPERATION CHECKLIST Ensure that the console support screws are tight. Make sure the Recumbent Exercise Bike is properly leveled and stable. Ensure that the Leveler Jam Nuts are tight. Read the entire Operation Manual before using the Recumbent Exercise Bike. Before attempting to operate your Recumbent Exercise Bike, it is imperative that you familiarize yourself with the contents of the Operation Manual.