95Ci, 93C, 90C, C9i, C7 Upright Exercise Bikes Assembly Instructions
Congratulations... and welcome to the world of The following Parts Identification Listing and the step by step assembly procedures have been assembled to make the set-up of the Exercise Bikes as quick and easy as possible. Please take special note of the following important points prior to choosing a location and beginning assembly of the Exercise Bikes.
IMPORTANT SAFETY INSTRUCTIONS! ⇒ DO NOT locate the Exercise Bike outdoors, near swimming pools, or in areas of high humidity. ⇒ DO NOT operate your Exercise Bike if it has been dropped, damaged, or even partially immersed in water. Contact Life Fitness Customer Support Services at the number in the Operation Manual. ⇒ DO NOT locate the Exercise Bike any closer than 30 inches ( 76 cm ) to a television set.
TOOLS REQUIRED FOR ASSEMBLY...
1 4 11 12 6 2 2 3 8 2 1 7 15
1. Locate the BOTTOM POLAR COVER (#6). Position the cover as shown with the notch of the center hole facing downward. Slide the BOTTOM POLAR COVER down over the UPPER CONSOLE SUPPORT TUBE (A) until it rests against the FRONT TUBE EXTENSION (B). 4 2. Position the HANDLEBAR (#11) as shown near the UPPER 12 CONSOLE SUPPORT TUBE (A). 3.
12. Models 95Ci, 93C, and 90C Only Locate the USER LEFT AND RIGHT SEAT POST COVERS (#7 & #8). Position the USER LEFT SEAT POST COVER (#7) below the seat covering the ADJUSTMENT LEVER (F) as shown. Interlock the two tabs of the USER RIGHT SEAT POST COVER (#8) to the corresponding slots of the USER LEFT SEAT POST COVER and pivot it forward to meet the USER LEFT SEAT POST COVER enclosing the SEAT ADJUSTMENT LEVER. Secure the SEAT POST COVERS together using one SCREW (#15). 10 13.
©2003 Life Fitness, a division of Brunswick Corporation. All rights reserved. Life Fitness is trademark of Brunswick Corporation. Polar is a registered trademark of Polar Electro, Inc. MO51-00K63-A081 06.
