User Guide

17
Optional Lifebreath Wireless Timer - Part #99-DET02
Installation of Wireless Timer
1. Separate the Face Plate from the Back Plate by firmly pulling apart (Figure A).
2. For mounting the control without a Decora plate, break off top and bottom tabs and refer to Figure C for mounting.
3. Place the Back Plate of the control in the desired location on the wall and pencil mark the top and bottom screw
holes (Figure B or C). Drill two 1/8" holes.
4. Attach the Back Plate to the wall using the 2 supplied screws and anchors.
5. Attach the Face Plate to the Back Plate (Figure A).
Face Plate
Back Plate
Removable
Back Plate
20/40/60 minute
status lights
Select Button initiates
high speed ventilation
for 20, 40 or 60 min.
Battery Indicator
Overview of Lifebreath Wireless 20/40/60 Minute Timer
Initiates HIGH speed Ventilation for 20, 40 or 60 minutes. The 20/40/60
minute Status Lights indicate HIGH speed operation.
Wireless Timers have an estimated range of 40' with no obstructions. To
increase the range of a Wireless Timer a 99-RX02 Repeater may be used.
Using the Wireless Timer
When paired to the main wall control, the Wireless Timer may be moved to
a remote location in the home such as a bathroom.
Pressing the Select Button on the Timer will initiate HIGH speed fan opera-
tion. The corresponding Status Light will illuminate under the number on
the Timer to indicate either 20, 40 or 60 minutes of HIGH speed fan opera-
tion. To cancel the call for HIGH speed fan operation, press the Select
Button until the Status Lights are no longer illuminated.
Replacing the Battery
When the battery needs to be replaced in the Wireless Timer, the red LED
Battery Indicator will illuminate.
To replace the battery, first remove the Face Plate by pulling it off the wall.
On the back of the Timer Face Plate the battery will be exposed. Replace
the battery and re-attach the Face Pate to the Back Plate. Be careful not
to damage the tabs on the Back Plate when re-attaching the Face Plate.
Back of
99-DET02
Face Plate
Battery