Install Instructions

18
Installation and Operation 20/40/60 Minute Timer: 99-DET01
Status
Lights
Select Button
initiates high
speed ventilation
for 20, 40 0r 60 min.
Yellow
Red
Green
Operating your Lifebreath 20/40/60 Minute Fan Timer
Press and release the Select Button to activate a 20, 40 or 60 minute high speed
override cycle. The Light will illuminate and the unit will run on high speed
ventilation for the selected time. The Light will dim after 10 sec. for run time. The
Light will flash during the last 5 min. of the cycle. The timer connected to the
unit will illuminate for the duration of the override when the Select Button is
pressed.
Lockout Mode
Lockout Mode is useful if you wish to disable the timers.
The timer can be set to lockout mode by pressing and holding the Select Button for five seconds. After 5 sec.,
the Light will flash; release the Select Button. The timer is now in lockout mode. If the Select Button is pressed
during lockout mode the Light will momentarily illuminate but no override will be initiated.
If lockout mode is initiated when the timer is activated, the timer will continue its timed sequence but will not
allow any further overrides to be initiated. Lockout mode can be unlocked by pressing and holding the Select
Button for 5 sec. After 5 sec. the Light will stop flashing. Release the Select Button and the timer will now
operate normally.