User Manual

UV Installation: UV is an OPTIONAL add-on feature for UNO, DUO and TRIO Filter Kits. You can purchase it directly from the

manufacturer (contact information listed below). Adding UV helps control Algae and Disease in your system. Fig – 10A shows the

components of your UV Kit. Install the UV Bulb (Item # 13) into the Ballast Connecter Item # 14) (see Fig – 10B). Install the O-Ring

(Item # 16) onto the Quartz Sleeve (Item # 15) as seen in Fig – 10C. The tapered end of the O-Ring slides onto the Quartz Sleeve first

as seen in Fig – 10C and 10D. Slide the Quartz Sleeve with the O-Ring onto the UV Bulb as shown in Fig – 10E. The Quartz Sleeve

should slide into the groove of the Clear View Cover (Fig – 11A). Slide the complete assembly into the filter base (Fig – 10F). Align the

Guide Notch (Fig – 11B and 10G) on the Filter base with the Clear View Cover and push it all the way in (Fig – 10G). Lock the

assembly in place with the UV Light Cover Nut (Item #19). Make sure the Ballast (Item # 14) is not exposed to moisture and the wiring

is laid out safely. Connect the Ballast cable to power. You should see the Blue Glow of the UV Light. NOTE – In case of any water

contact with the electrical components the circuit breaker will trip.

Clear

–

UV Cover

Fig

–

11A

Guide Notches

Fig

–

10A

Fig

–

10B

Fig

–

10C

Fig

–

10D

Fig

–

10E

Fig

–

10F

Fig

–

10G

Fig

–

10H

Fig

–

11B