User Manual

Step – 3 Removal of Optional UV Chamber Housing (Item # 11) and Pump Replacement Base (Item # 23). After removing the layers

you will see the Biological Media Bag (Item # 10), UV Chamber Housing (Item # 11) and Pump Replacement Base (Item # 23). Take

out the Biological Media Bag (Item # 10). Gently push the UV Chamber Housing (Item # 11) off of the Pump to UV Chamber Adapter

(Item # 22) as seen in Fig – 3. Than slide it off of the UV Housing Chamber holder on the base (Fig – 3A).

Now push out the Pump Replacement Base (Item # 23). It should slide along the guides. You may need to use some force to unhinge it

off of the Pump Lock Notch as seen in Fig – 3.

To Install the UV Chamber (Item # 11) first slide it into the UV Chamber opening as see in Fig. 4A and then gently push it into the Pump

to UV Chamber Adapter (Item # 22). The O-Ring on the Pump to UV Chamber Adapter (Item # 22) should be properly inserted into the

UV Chamber Housing (Item # 11). Once both parts – Pump Replacement Base and UV Chamber are locked in place correctly the

screw openings on the UV Chamber will align and you can lock it with Screws (See Fig – 4B). The Biological Media bag (Item # 10)

should be by the UV Chamber Opening opposite the Pump Replacement Base (see Fig – 4C).

Step – 2: Once all the parts are inspected for correct positioning make sure that the Solid Rubber Cord Grommet (Item # 21) is correctly

locked in its slot (see Fig – 2C).

Rubber Cord Grommet

Fig

–

Fig

–

Fig

–

Fig

–

Fig

–

UV Housing Chamber holder

Fig

–

Fig

–

Pump Base Wall

Pump Lock Notch

Correct Installation – No Gap

Fig

–

Fig

–

Fig

–

Fig

–

Fig

–