User Manual

Step – 2: Once all the parts are inspected for correct positioning make sure that the pump cable is running through the

locks and is locked in place with the Rubber Cord Grommet (Item # 20) (as seen in Fig. 2A).

Step – 3: Correctly place the layer (s) back on the base by sliding the Locking notches into the Notch Holders. Similarly

place the Top Housing Cover and Lock it in with the Locking Assembly. Now you are ready to put the 1” Nipple, Leveling

Fitting for Fountain Kit, Diverter Valve and the Fountain Kit Complete (in the same order) (Item # 3,4,5,6).

UV Installation:

Put the UV bulb (Item # 13) in the 2-Pin Ballast connector (Item # 14). Slide the black rubber Gasket of Quartz Sleeve

(Item # 16) onto the open rim of the Quartz Sleeve (Item # 15) so that the flat end of the gasket faces out to the Clear UV

Cover. Slide the Quartz Sleeve (Item # 16) into the round notch of the Clear UV Cover (Item # 19). Now hold the Clear UV

Cover and slide the quartz sleeve into the UV Chamber. Align the two Guide Notches with the opening on the Clear UV

Cover. Close the Nut and hand tighten only.

Pump Installation:

It is recommended that you service the Quiet One Pump (Item # 24) every three month to enhance its efficiency and the

life of the moving parts. Before you start to service the pump – first “REMOVE” the UV bulb (Item # 13) and Sleeve (Item #

15) from the unit. Not doing this first you risk cracking the Quartz Sleeve and UV Bulb. To service the pump follow Step –

1 to remove the top cover, Filter layers and the Biological media bag. With the Quartz Sleeve and UV Bulb out of the

chamber remove the UV housing Cover by removing the screws that hold it in place (as seen in Fig. 4).

Step – 4: Gently slide the UV Housing Cover (Item # 11) by first sliding it out from the pump and then the base UV seal.

The pump is locked onto the base with horizontal notches (as seen in Fig. 5). NOTE the position of the pump when it is

locked onto the base. Once this process is complete you will have to lock the pump back into the same position. With the

pump fully exposed push it out horizontally along the notches. NOTE – You may have to place the filter base sideways

Clear

–

UV Cover

Fig. 3

Guide Notches

Fig. 4