Operation Manual

17
7. Computer and Handlebar Installation
Remove four M5x10 Bolts (88) from the back of the Computer (53).
Remove two M8x15 Bolts (38) and Ø16xØ8 Curve Washers (93) from the Front Post (5).
Insert the Hand Pulse Sensor Wires (55) from the Handlebar (6) into the hole on the Front
Post (5) and then pull them out from the top end of the Front Post (5).
Attach the Handlebar (6) onto the Front Post (5) with two M8x15 Bolts (38) and Ø16xØ8
Curve Washers (93) that were removed.
Connect the Sensor Wire I (64) and Hand Pulse Sensor Wires (55) to the wires that come
from the Computer (53) and then attach the Computer (53) onto the top end of the Front
Post (5) with four M5x10 Bolts (88) that were removed.
Multi Hex Tool with Phillips
Screwdriver S8, S13, S14, S15
Allen Wrench 6mm
Tool:
5
53
64
88
55
93
38
6