Operation Manual

6. Computer Installation

Remove two M5x10 Bolts (57) from the back of the Computer (56). Remove bolts with the

Multi Hex Tool with Phillips Screwdriver provided.

Insert the Hand Pulse Sensor Spring Wires (62) from Left/Right Handrails (4L, 4R) into the

hole on the Front Post (5) and then pull them out from the top end of the Front Post (5).

Connect the Sensor Wire I (67) and Hand Pulse Sensor Spring Wires (62) to the wires that

come from the Computer (56) and then attach the Computer (56) onto the top end of the

Front Post (5) with two M5x10 Bolts (57) that were removed. Tighten bolts with the Multi

Hex Tool with Phillips Screwdriver provided.

Multi Hex Tool with Phillips Screwdriver

S10, S13, S14, S15

Tool: