Operation Manual

11
3. Backrest Support Bracket and Handlebar Installation
Attach the Backrest Support Bracket (1) onto the Rear Main Frame (3) with four M8x15 Bolts
(23), four Ø8 Flat Washers (24), and two M8 Cap Nuts (71). Tighten bolts and cap nut with
the S6 Allen Wrench and Multi Hex Tool with Phillips Screwdriver provided.
Attach the Handlebar (13) onto the Backrest Support Bracket (1) with two M8x45 Bolts (70),
two Ø8.4xØ25x2 Big Curve Washers (25), two Ø8 Flat Washers (24), and two M8 Cap Nuts
(71). Tighten bolts and cap nut with the S6 Allen Wrench and Multi Hex Tool with Phillips
Screwdriver provided.
Connect the Hand Pulse Sensor Wires (68) from the Handlebar (13) to the Extension Hand
Pulse Sensor Wires I (65) from the Rear Main Frame (3).
Hardware:
1
13
65
68
24
23
24
23
3
71
71
71
24
70
25
Allen Wrench S6
Tool:
Multi Hex Tool with Phillips Screwdriver
S10, S13, S14, S15
(23) Bolt M8x15
4 PCS
(24) Flat Washer Ø8
6 PCS
(25) Big Curve Washer
Ø8.4xØ25x2
2 PCS
(70) Bolt M8x45
2 PCS
(71) Cap Nut M8
4 PCS