Operation Manual

10
5. Handlebar Post and Tension Control Knob Installation
Slide the Handlebar Post Cover (47) onto the Main Frame (1).
Remove one M8x15 Bolt (24), one Ø20xØ8 Curve Washer (57), four Ø8 Washers (38), and
four M8x10 Bolts (62) from the Main Frame (1).
Insert the Tension Cable (58) through into the bottom hole of Handlebar Post (3) and pull it
out from the square hole of Handlebar Post (3).
Connect the Sensor Wire (26) from the Main Frame (1) to the Middle Section Sensor Wire
(59) from the Handlebar Post (3).
Insert the Handlebar Post (3) onto the tube of the Main Frame (1) and secure with one
M8x15 Bolt (24), one Ø20xØ8 Curve Washer (57), four Ø8 Washers (38), and four M8x10
Bolts (62) that were removed.
Remove the M5x20 Bolt (48) and Ø5 Big Washer (54) from the Tension Control Knob (7).
Put the cable end of resistance cable of Tension Control Knob (7) into the spring hook of
Tension Cable (58) as shown in drawing A of figure 5. Pull the resistance cable of Tension
Control Knob (7) up and force it into the gap of metal bracket of Tension Cable (58) as shown
in drawing B of figure 5. Attach the Tension Control Knob (7) onto the Handlebar Post (3)
with the M5x25 Bolt (48) and Ø5 Big Washer (54) that were removed.
Multi Hex Tool with Phillips
Screwdriver S13, S14, S15
Allen Wrench 6mm
Tool:
58
7
59
54
48
3
1
62
38
38
62
26
59
47
58
24
57
A B
7
7
58
58