Operation Manual

9
Insert the pedal shaft of Left Foot Pedal (44) into threaded hole in the left Crank (39).
Turn the pedal shaft by hand in the counter-clockwise direction until snug.
Note: DO NOT turn the pedal shaft in the clockwise direction, doing so will strip the
threads.
Tighten the pedal shaft of Left Foot Pedal (44) with the Multi Hex Tool with Phillips
Screwdriver provided.
Insert pedal shaft of Right Foot Pedal (45) into threaded hole in right Crank (39).
Turn the pedal shaft by hand in the clockwise direction until snug.
Tighten pedal shaft of Right Foot Pedal (45) with the Multi Hex Tool with Phillips Screwdriver
provided.
․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․
4. Handlebar and Computer Installation
Remove two M8x15 Bolts (19) and two Ø16xØ8x1.5 Curve Washers (64) from the
Handlebar Post (7). Remove bolts with the S6 Allen Wrench provided.
Insert the Hand Pulse Sensor Wires (49) into the hole on the Handlebar Post (7) and then
pull them out from the top end of the Handlebar Post (7).
Attach the Handlebar (8) onto the Handlebar Post (7) with two M8x15 Bolts (19) and two
Ø16xØ8x1.5 Curve Washers (64) that were removed. Tighten bolts with the S6 Allen
Wrench provided.
Remove four M5x10 Bolts (42) from the Computer (62). Remove bolts with the Multi Hex
Tool with Phillips Screwdriver provided.
Connect the Hand Pulse Sensor Wires (49) and Extension Sensor Wire (63) to the wires that
come from the Computer (62). Tuck wires into the Handlebar Post (7).
Attach the Computer (62) onto the top end of the Handlebar Post (7) with four M5x10 Bolts
(42) that were removed. Tighten bolts with the Multi Hex Tool with Phillips Screwdriver
provided.
Multi Hex Tool with Phillips Screwdriver
S10, S13, S14, S15
Allen Wrench S6
Tool:
62
8
42
63
49
19
7
49
64