Operation Manual

8
3. Handlebar Post, Tension Control Knob, and Foot Pedals Installation
Remove four M8x15 Bolt (19) and four Ø8xØ20x2 Big Curve Washers (14) from the Main
Frame (1). Remove bolts with the S6 Allen Wrench provided.
Slide the Handlebar Post Cover (58) up to the Handlebar Post (7).
Insert the Tension Cable (55) through into the bottom hole of Handlebar Post (7) and pull it
out from the square hole of Handlebar Post (7).
Connect the Sensor Wire (50) from the Main Frame (1) to the Extension Sensor Wire (63)
from the Handlebar Post (7).
Insert the Handlebar Post (7) onto the tube of the Main Frame (1) and secure with four
M8x15 Bolt (19) and four Ø8xØ20x2 Big Curve Washers (14) that were removed. Tighten
bolts with the S6 Allen Wrench provided. Slide the Handlebar Post Cover (58) down to the
Main Frame (1).
Remove the M5x45 Bolt (40) and Ø5xØ15x1 Big Curve Washer (41) from the Tension
Control Knob (54). Remove bolt with the Multi Hex Tool with Phillips Screwdriver provided.
Put the cable end of resistance cable of Tension Control Knob (54) into the spring hook of
Tension Cable (55) as shown in drawing A of figure 3. Pull the resistance cable of Tension
Control Knob (54) up and force it into the gap of metal bracket of Tension Cable (55) as
shown in drawing B of figure 3. Attach the Tension Control Knob (54) onto the Handlebar
Post (7) with the M5x45 Bolt (40) and Ø5xØ15x1 Big Curve Washer (41) that were removed.
Tighten bolt with the Multi Hex Tool with Phillips Screwdriver provided.
Foot Pedals Installation
The Cranks, Foot Pedals, Pedal Shafts and Pedal Straps are marked “R” for Right and
“L” for Left.
Multi Hex Tool with Phillips Screwdriver
S10, S13, S14, S15
Allen Wrench S6
Tool:
54
54
41
41
40
40
63
63
19
19
19
19
14
14
14
14
19
19
14
14
58
58
55
55
50
50
7
39
39
45
45
44
44
1
54
54
55
55
54
54
55
55
BA