Operation Manual

14
5. Handlebar and Computer Installation
Remove four M5x12 Bolts (57) from the back of the Computer (56). Remove bolts with the
5mm Allen Wrench with Phillips Screwdriver provided.
Insert the Hand Pulse Sensor Wires (58) from the Handlebar (6) into the hole on the Front
Post (5) and then pull them out from the top end of the Front Post (5).
Attach the Handlebar (6) onto the Front Post (5) with two M8x16 Bolts (41), two Ø8 Spring
Washers (60), and two Ø16xØ8 Curve Washers (42). Tighten bolts with the 5mm Allen
Wrench with Phillips Screwdriver provided.
Connect the Extension Sensor Wire (67) and Hand Pulse Sensor Wires (58) to the wires that
come from the Computer (56) and then attach the Computer (56) onto the top end of the
Front Post (5) with four M5x12 Bolts (57) that were removed. Tighten bolts with the 5mm
Allen Wrench with Phillips Screwdriver provided.
Hardware:
(41) Bolt M8x16
2 PCS
(60) Spring Washer Ø8
2 PCS
(42) Curve Washer
Ø16xØ8
2 PCS
Allen Wrench with Phillips
Screwdriver 5mm
Tool:
5
56
67
57
58
41
6
58
42
60