Operation Manual

10
4. Handlebar Post and Handlebar Post Cover Installation
Remove five M8x15 Bolts (24) and four Ø8 Washers (38) from the Main Frame (1).
Remove bolts with the 5mm Allen Wrench provided.
Slide the Handlebar Post Cover (64) up to the Handlebar Post (3).
Connect the Sensor Wire (26) from the Main Frame (1) to the Extension Sensor Wire (59)
from the Handlebar Post (3).
Put the cable end of resistance cable of Tension Control Knob (7) into the spring hook of
Tension Cable (58), see Figure A. Pull the resistance cable of Tension Control Knob (7) up
and force it into the gap of metal bracket of Tension Cable (58), see Figure B.
Insert the Handlebar Post (3) onto the tube of the Main Frame (1) and secure with five
M8x15 Bolts (24) and four Ø8 Washers (38) that were removed. Tighten bolts with the
5mm Allen Wrench provided.
Slide the Handlebar Post Cover (64) down to the Handlebar Post (3).
Allen Wrench 5mm
Tool:
A B
7
7
58
58
38
24
24
38
24
64
58
26
59
7
3
1
A B
7
7
58
58