Operation Manual

6. Handlebar and Computer Installation

Remove four M5x12 Bolts (57) from the back of the Computer (56). Remove bolts with the

Multi Hex Tool with Phillips Screwdriver provided.

Remove two M8x15 Bolts (41) and two Ø8 Big Curve Washers (14) from the Front Post (5).

Remove bolts with the 5mm Allen Wrench provided.

Insert the Hand Pulse Sensor Wires (58) from the Handlebar (6) into the hole on the Front

Post (5) and then pull them out from the top end of the Front Post (5).

Attach the Handlebar (6) onto the Front Post (5) with two M8x15 Bolts (41) and two Ø8 Big

Curve Washers (14) that were removed. Tighten bolts with the 5mm Allen Wrench

provided.

Connect the Extension Sensor Wire (67) and Hand Pulse Sensor Wires (58) to the wires that

come from the Computer (56) and then attach the Computer (56) onto the top end of the

Front Post (5) with four M5x12 Bolts (57) that were removed. Tighten bolts with the Multi

Hex Tool with Phillips Screwdriver provided.

Multi Hex Tool with

Phillips Screwdriver

S8, S13, S14, S15

Tool:

Allen Wrench 5mm