Use Instructions
55
Questions? Call 1-800-635-6156
The GoSafe 2 Mobile Pendant (7250MHB) complies with relevant laws and standards
on electro-magnetic compatibility (EMC) for this type of product when used as
intended. Such laws and standards dene both the permissible electromagnetic
emission levels from this product and its required immunity to electromagnetic
interference from external sources.
The GoSafe 2 Mobile Pendant (7250MHB) must emit electromagnetic energy in order
to perform its intended function. Nearby electronic equipment may be aected.
Medical Electrical Equipment needs special precautions regarding EMC and needs
to be installed and put into service according to the EMC information provided in the
accompanying documents.
Other electronic products exceeding the limits dened in such EMC standards could,
under unusual circumstances, aect the operation of the product.
1. Medical Electrical Equipment needs special precautions regarding EMC and needs
to be installed and put into service according to the EMC information provided in the
Accompanying Documents.
2. Other equipment such as Portable and Mobile RF Communications Equipment may
interfere with the medical device even if the other equipment complies with CISPR
emission requirements .
3. The use of accessories and cables other than those specied, with the exception
of those sold by the manufacturer may result in increased emissions or decreased
immunity of the equipment or system.
4. The equipment or system should not be used adjacent to or stacked with other
equipment. If adjacent or stacked use is necessary, the equipment or system should
be observed to verify normal operation in the conguration in which it will be used.
EMC Informational Tables
Note: The emissions characteristics of this equipment make it suitable for use in
a residential environment (for which CISPR 11 class B is normally required). This
equipment might not oer adequate protection to radio-frequency communication
services. The User might need to take mitigation measures, such as relocating or re-
orienting the equipment.
Warnings
Portable RF communications equipment (including peripherals such as antenna
cables and external antennas) should be used no closer than 30 cm (12 inches) to any
part of the 7250MHB. Otherwise, degradation of the performance of this equipment
could result.
MHB3_7250_IFU 2020c.indd 55 2/15/21 2:28 PM