Installation Guide

7
January 1, 2020
Please contact 800-273-1143 for further assistance.
Installing Under Doorway Frames
15. Whenthenewooringmeetsathresholdoradoorway,werecommendundercuttingthedoorjamb.To
securetherightcut,turnaplankupsidedownandplaceitontheooruptothedoorframe.Thenplacea
reciprocatingsawatagainsttheplankandsimplycutthroughtheframe.Removethecut-outpieceand
vacuumawaydebris.Slideplankunderpre-cutdoorframe.Doorframeshouldbecutsothata¼"(6mm)
gap is located from the edge of the plank under the casing to the wall.
16. Tapthelongsidejointclosedrst,thentaptheendjointclosed.
15 16
Installing Around Fixed Objects
17. Allow¼"(6mm)expansionspacearoundpipesorotherxedobjects.
18. Inrowswherethereisapipe,makesurethepipefallsexactlyinlinewiththeshortsideoftwoplanks.
Selectadrillbitwiththesamediameterasthepipeplus1/2inch(13mm).Clicktheplankstogetheron
the short side and drill a hole centered on the joint between the two planks. Then install the planks.
19. Foradoublepipe,drillaholeequivalenttothediameterofthepipeplus1/2inch(13mm)ateachofthe
markedpoints.Iflocatedonthelongsideoftheplank,makea45ºcutfromeachholetotheedgeofthe
plank. Then, using an appropriate glue along the cut edges of the piece you cut out, glue the piece in
place.Besurenogluecomesbetweenthecut-outpieceandthesuboor.
17 18 18a
19 19a 19b 19c