Installation Guide

1 HOMEDEPOT.COM/LIFEPROOF
March 12, 2019 Please contact 1-866-843-8453 for further assistance.
RIGID CORE LUXURY VINYL PLANK FLOORING
MULTI-WIDTH INSTALLATION INSTRUCTIONS
Product Description
6.5mm x 4.25", 5.59", 9.84" x 47.64"
(6.5mm x 108, 142, 250 x 1210mm)
Grade Levels
Above Grade / On Grade
/ Below Grade
Installation Method
Floating - Drop and Lock
Installation Video available on YouTube
LifeProof
TM
is intended for interior use only and is suitable for above
grade, on grade, and below grade applications. DO NOT install in any
outside areas, sunrooms/solariums, saunas, seasonal porches, camping
trailers, boats, RVs, 3-season rooms, lanais, rooms that are prone to
flooding, or rooms or homes that are not temperature-controlled.
LifeProof
TM
is a floating floor and should be allowed to expand and
contract freely. It must not be glued, nailed, or fastened to the subfloor in
any way. Permanent cabinets, vanities, islands and similar items should
be installed first. Then, install LifeProof
TM
around them, leaving the proper
expansion gap. LifeProof
TM
can be installed under vanities with legs.
LifeProof
TM
can be installed under toilets; leave proper expansion space
around flange and use a premium waterproof 100% silicone caulk. Do
not anchor toilet through the material.
LifeProof
TM
is a waterproof floating floor, but it should not be used to
seal an existing floor from moisture. It cannot inhibit the growth of mold
or prevent structural problems associated with, or caused by flooding,
excessive moisture, alkalis in the subfloor, or conditions arising from
hydrostatic pressure. Regardless of location, always remove standing
water, urine and other liquids promptly. Job site moisture issues should
be addressed and corrected prior to installation. Fill expansion spaces
around potential wet areas only with premium waterproof 100% silicone
caulk.
Long-term exposure to direct sunlight can potentially damage LifeProof
TM
,
causing it to discolor, fade, or buckle. Protect LifeProof
TM
from exposure
to direct sunlight via the use of window-treatments or via UV-tinting on
windows.
If the flooring is to be installed by a third party, then it is suggested that
the homeowner to be present during the installation for consultation/
direction. The owner and installer should discuss installation and layout
to maximize satisfaction. If this is not possible, consultation should
occur prior to installation. The owner/installer assumes all responsibility
for quality of completed installation.
Tools for Installation:
Utility Knife Straight Edge
Measuring Tape ¼" (6mm) Spacers
Pencils Profiled Tapping Block
Pull Bar Eye Protection
Soft-Faced Hammer Broom
Felt or Nylon Pads
Optional: Jig Saw, Table Saw, Miter Saw, Circular Saw, Hole Saw,
Moisture Meter (wood, concrete, or both)*
*Tools may be available for rent at The Home Depot.
Overage Allowances
Order 10% more flooring than square footage to
account for cuttings and waste
Subfloor Flatness
Tolerances
¼" in 10ft., Slope not more than 1" per 6 ft.
(6mm in 3m, Slope not more than 25mm per 1.8m)
No abrupt height differences. High spots should
be sanded or ground down and low areas
should be filled
Vapor Barrier (6 mil
polyfilm)
Not Required
Should Underlayment
(pad) be used?
No - LifeProof
TM
includes a pre-attached sound-
mitigating pad. Do not use any additional sound
suppression underlayment or padding, as doing
so will void the LifeProof
TM
Limited Warranty
Acclimation
Requirements
Residential - Not Required
Light Commercial - 48 Hours
Transition
Requirements
Required when installing LifeProof
TM
in a room or
area that is larger than 100 lineal ft. (30.5m) in
any direction
Installation On Stairs or
Vertical Surfaces (walls)
Voids Warranty
Installation Over
Existing Ceramic Tile
Floors
Filling Grout Lines Not Required
(Follow Subfloor Flatness Tolerances)
Glue Down Installation Voids Warranty
Subfloor RH/MVER
Recommendations
85% Relative Humidity / 8 lbs. MVER (Moisture
Vapor Emission Rating
Radiant Heat Approved - See page 3
3-Season/Non-
Climate Controlled
Environments
Voids Warranty
Expansion Gap
Requirements
¼" (6mm) around perimeter walls & heavy fixed
objects such as cabinetry or baths
Required Interior
Environmental
Conditions
50ºF–100ºF (10ºC–38ºC)
Definition of
“Waterproof”
Structural integrity of LifeProof
TM
flooring will not
degrade due to contact with moisture/water
KEY INSTALLATION CONSIDERATIONS

Summary of content (14 pages)