Use And Care Manual

18
C. PICK ONE DEVICE
NOTE: This chosen device will be the “Coordinator” of the wireless alarm
network. Keep this unit separated from the others. For best results, after
wireless setup is complete, install the Coordinator in a central location.
Press and hold the button on only the Coordinator until you hear two beeps.
Release button. You will hear “Searching for other devices”.
• The light will pulse and device will sound a continuous “Sonar” ping until step E is complete.
D. RELAX AND WAIT
NOTE: For reference, these non-Coordinator units are called “RFDs”.
Wait until all other devices (RFDs) have connected to the network. Once
connected, each device will speak, “Success now connected!”
• Once connected, the lights will glow green.
E. PICK ONE DEVICE
Press and hold the button on only ONE device until you hear 2 beeps.
Release button. “Sonar” ping will stop.
• Device will announce that setup is complete and the number of connect-
ed devices.
F. WIRELESS SETUP COMPLETE!
If all devices flash green and “Sonar” ping has stopped, the devices are now connected. Congratulations!
IMPORTANT: If for some reason, you forget which unit is the Coordinator, follow these simple steps to re-confirm
the Coordinator and the RFD units.
1. Press and hold the button on any unit for 4-5 seconds until 2 beeps are heard. Release button.
2. Observe the LED ring on each unit. The Coordinator will be fading green on/off every 2 seconds. The RFDs will
be fading green on/off every 4 seconds.
3. After confirming the Coordinator, press and hold the button on any unit for 4-5 seconds until 2 beeps are heard.
Figure 9.1-E
Hold for
5 seconds
Figure 9.1-D
“Success, now
connected!”
Figure 9.1-C
DON'T press buttons
on other devices
“Searching for
other devices.”
Hold for
5 seconds