User's Manual Part 2

USING YOUR SECURITY SYSTEM
[www.LifeShield.com]
[62]
Event Log/Network Configuration
Alarm Event Log (Handset/Console)
For Alarm Monitoring subscribers the system will log all messages (in an Event Log) sent to the Alarm Monitoring Center.
This is separate from the entire Recent Event log on www.LifeShield.com. These messages can be viewed from your Handset
or Console
:
1. Press MENU
2. Scroll to Security Setup, press SELECT
3. Enter your Master Code
4. Scroll to Event Log, press SELECT
Network Configurations
Your LifeShield system usually connects to your Internet (broadband) network automatically using the same DHCP protocol as
your PC or laptop. However, some networks use Static IP Addresses. If you are not familiar with Static IP Address, it is likely that
your network does not have this requirement. If you do require a Static IP Address, complete this setup process from either your
Handset or Console:
1. Press MENU
2. Scroll to Security Setup, press SELECT
3. Scroll to Network Mode, press SELECT
4. Scroll to Address Type, press SELECT
5. SELECT Static, press OK
6. SELECT View/Edit
7. Enter the following information and press OK as you complete each step:
IP Address
Gateway
SubnetMsk
PrimDNS
Second DNS
MAC Address
Power Outage
Your LifeShield Home Security system operates on AC power and battery backup. In the event that both AC and battery
power is lost while the system is armed, your system will automatically return to the armed state when the power is restored.
After a complete AC and battery outage, the system will wait 1 minute before responding to Sensor activity once power is re-
stored.
i
You can receive notifications on
your email, mobile device, and/or
Home Alert for any event in your
system. Set these up at
www.LifeShield.com, Security tab,
Recent Events window,
notification setup button.