User's Manual Part 2

Glossary
SUPPLEMENTAL INFORMATION
[www.LifeShield.com]
[92]
Alarm
The sound that is heard when your system is armed and a Sensor has been faulted or when the PANIC button has been pressed.
Alarm Notification Delay
When an alarm sounds, a notification signal is sent to the Alarm Monitoring Center after a delay of 30 seconds. The delay provides time for you to cancel a false
alarm.
Arming Your System
Arming Your System means turning your system on to secure your premises.
Auto Answer
When enabled, a call will be active when the Handset is picked up off the Charging Cradle. TALK/END does not need to be pressed.
Auto Stay
When the system is armed Away, but you don't leave the house, the system defaults back to armed Stay status. To override this default setting Auto Stay can be
set to "No" on LifeShield.com.
AWAY (Leaving Home)
Arm AWAY when leaving your home. All Sensors are monitored (except those designated as a “Non-Monitored Type”). An audible Exit Delay and Entry Delay is
supported.
Base
One of 3 Grid Controllers. The Base provides the system Internet access and phone line backup.
Bypassing a Sensor
Bypassing a Sensor allows you to arm your system without monitoring or creating an alarm condition when a Sensor is opened.
Charger
The Charger is provided with, and is used to charge, the Handset.
Chime
A Chime is the sound made when a Sensor is opened or closed. Chimes can be turned off globally from both the Handset and Console by pressing the Chime but-
ton and entering your User Code.
Comm. Test
The communication test verifies alarms can be sent across both the Internet and your phone line to the Alarm Monitoring Center. This is done automatically during
activation, but should be run periodically to verify communications.
Console
One of 3 Grid Controllers. The Console provides full feature display and keypad for operating the system.
Direct to Answer
Direct to Answer sends an incoming call directly to the Answering System, rather than answering the call.
Disarming Your System
Turning your security system off. Disarming your system is done by pressing CANCEL/Off on your Handset or Console and then entering your User Code.
Display Messages
Messages on the screen of your Handset or Console. Line 1 displays security status messages. Line 2 displays secondary security status messages. Line 3
displays phone status messages.