User's Manual Part 2

System Messages
SUPPLEMENTAL INFORMATION
[www.LifeShield.com]
[103]
Secondary Security Display Messages
The following table lists and describes the Secondary Security Display Messages of your LifeShield Home Security system.
Table 9: Secondary Security Display Messages
Display Message Display Description
Not Monitored Message displayed when the system is Armed but is not being monitored by the Alarm Monitoring Center.
Synchronizing Message displayed if the system has temporarily lost grid communication and is in the process of reestablishing.
Not Activated Message displayed if the system has not been activated.
Not Registered
Message displayed on a Handset or Console if that device has not been registered into any system. The Handset or Console
cannot perform any functions until it has been registered into a system.
Bypass on Message displayed when a Sensor has been bypassed.
No Phone Line
Message displayed when the system detects that your phone line has been disconnected from one of the GCs. If a phone line is
available at another GC, the system will reconfigure itself in approximately 10 seconds.
No Internet
Message displayed when the system has lost communications to the Internet. This can be caused by a network outage by your broadband provider,
loss of AC power to your cable or DSL modem, a PPOE problem, loss of power to your router, failure of the router, or a wire disconnection.
LoBat: Device Name:
Message displayed when a device has a low battery condition. If the device is a Handset, place the Handset on a Base or Charger.
If the device is a Base, Console, or Grid Extender, make sure that the battery is connected and AC power is available to charge the
battery in the device. If the device is a Sensor or Keychain Remote, the battery is not rechargeable and must be replaced.
Sensor Name Open Message displayed when Sensor is faulted (open).
NoA/C: Device Name: Message displayed when a device has lost AC power.
Lost Device:
Device Name:
Message displayed when the system has lost communications with one of the devices in the system. The device may have lost
power or been moved out of wireless range of the system. During a system reset, this message may be displayed temporarily
while the system is reconfiguring itself.
Day, Date and Time
Example: Thurs. 12/20
3:05p
The time and date will be displayed when there are no system messages to display.