Installation Instructions
- The Base should not be mounted in location subject to temperatures over 122F (50C) or
below 32F (0C) for any extended period of time. This will degrade the battery life.
Mounting the Base
The Base may be placed horizontal on a shelf or a table top. The Base includes a non-skid
bottom that helps prevent the Base from moving due to the weight of cables. If you choose, the
Base also includes a slot compatible with keyed laptop locks (Kensington is one example brand
that makes these locks). This will allow you to lock the Base in place.
The Base may also be mounted on a wall or ceiling. The mounting bracket is attached to the wall
or ceiling, and the Base slides into the bracket as shown in Figure 1. Please note that the bracket
and Base are keyed and can only snap into each other one way. You may want to practice this
first before attaching the bracket to the wall or ceiling. When inserting the Base into the bracket,
be sure to slide the Base until fully engaged in the bracket. The non-skid surface of the Base is
designed to hold the Base into the bracket.
In all mounting conditions, it is highly recommended that you provide strain relief for any cables
attached to the rear of the Base. The Base provides a small slot and matching hole on the bottom.
A small cable tie (provided) should be inserted through this slot and then wrapped around any
cables attached to the rear, as shown in Figure 2, 3, and 4.
Figure 1: Mounting Bracket Figure 2: Cable Stress relief