Lifesmart Infrared Heater User’s Manual Model# LS‐Stealth‐1 FOR INDOOR USE ONLY 120VAC 15 AMP DEDICATED CIRCUIT The LIFESMART Infrared Heater works with your in‐home furnace to provide supplement heat. Carefully and thoroughly read this manual before using the LIFESMART Infrared Heater for the first time. We recommend keeping this manual for regular review and future reference. This heater is intended for residential use.
Introduction LIFESMART Infrared Heaters utilize the latest infrared heat technology. LifeSMART Infrared Heaters provide a safe, convenient, clean, and economical way to distribute heat throughout your home or business without producing deadly fumes or monoxide gases. Our heating system produces infrared heat that can potentially relieve symptoms of cardiovascular conditions and inflammatory diseases.
Warranty Limitations This warranty does not apply if the unit has been subject to negligence, fabrication, misuse, abuse, or repairs (unless authorized verbally, or in writing, by an Authorized LIFESMART Representative) alteration by non LIFESMART authorized personnel, inappropriate installations, or any case beyond the control of LIFESMART.
Unpacking the LIFESMART Infrared Heater Limited Manufacturer Warranty 1. First, check the carton to make sure there are no obvious damages that may have occurred during shipment. 2. Open the lifeSMART Infrared Heater packaging and remove the heater by sliding it from the box. You may want to gently and cautiously turn the entire box upside down letting the heater slowly slide out. 3. Remove all the protective materials from the heater.
Troubleshooting 1. PROBLEM: a. If the Heat Emitter is broken or damaged b. If the Control Panel is not responding, the temperature reading is above 860F/300C, or there is a burning odor coming from the portable heater c. Or if the power cord is damaged 2) By pressing the 0C/0F/Down button, you can switch the temperature format from Fahrenheit to Celsius and vice versa. 0 0 Press the C/ F/Down to switch from Fahrenheit to Celsius. SOLUTION: Contact the manufacture immediately.
4) Again, the default set temperature displayed on the LED display is 720F. By pressing the TEMP button, the LED display will switch to the temperature status and flash. You must press the HI/LOW/UP button or 0C/0F/DOWN button once again within (5) seconds to set the desired temperature. Each time you press the HI/LOW/UP button, the temperature setting will increase by 10F. Press the 0C/0F/DOWN button and the time will decrease by 10F. The maximum temperature setting is 860F (300C).
