Use and Care Manual

2
STEP 2: POWER IT UP!
Put the ‘hot’ in ‘hot tub’ with electricity! Ahhh,
there’s nothing better than a warm water
massage!
110 Volt: Plug the GFCI cord into the
designated wall outlet. In about 24 hours,
you’ll be ready to soak!
220 Volt: Turn on the breaker in the spa
subpanel after a licensed electrician installs
power. In just 6-8 short hours, you’ll be
relaxing in warm water.
HOT TUB TIP:
Your hot tub will automatically heat to 100°F
at startup. Use the +/- buttons to adjust the
temperature. After 5 seconds, the current
temperature will appear, climbing each degree
until it hits that perfect temp.
YOUR HOT TUB’S QUICK START GUIDE
Filter Filter Compartment Drain Door Panel Jets
COMPONENT LEGEND
CUSTOMER SERVICE
888-772-4359
[e-mail]
IMPORTANT Failure to read the Owner’s Manual and follow its instructions may result in
unsafe operation, permanent damage to your hot tub, and/or personal harm.
1
STEP 1: FILL IT UP!
Do not plug-in or turn on the
connected breaker before completely
lling your hot tub with water.
Before you can start soaking, you’ve
got to add some water. Here’s how to
achieve the perfect water level.
1. Remove lter and insert the hose
into the lter compartment.
2. Turn on the water and wait.
3. Fill until the water is
1” above the highest
jet, but not more than
6” below the top of
the spa. Replace lter
after lled.
HOT TUB TIP:
Remove door panel to check inside the
equipment compartment for water leaks
while lling the tub. If there’s a leak or if
anything doesn’t go according to plan,
we’re here to help!