Full Product Manual

13
Initial start-up - When the spa is first powered up, the control system
begins a 2 minute Startup Mode. Different codes will display on the
screen. Once Startup Mode completes, the actual temperature is
displayed on the screen. The spa will then begin to heat and maintain
the water temperature and the first filter cycle will start. Your spa
has been designed so that it will automatically heat the water to the
factory set temperature of 100°F (38°C) unless you set the spa to a
different temperature. If power is disconnected from the spa, it
will automatically revert back to the last saved set temperature
when power is reapplied. Depending on your spa model you will
either have a one pump or two pump control panel as illustrated.
TEMPERATURE ADJUSTMENT
The temperature can only function between 80°F - 104°F (26.5°C - 40°C). The last measured temperature
will constantly display on LCD.
1 Pump Model - Press the Up or Down buttons to display the set temperature and indicator
. Each time
either button is pressed again, the set temperature will increase or decrease depending on which button is
pressed. After five seconds, the LCD will automatically display the current spa temperature.
2 Pump Model - Press and hold the Temp button, the temperature will either go up or down. Release when
desired temperature is achieved. If desired temperature is in the opposite direction, press and hold a second
time to adjust the temperature and release when desired temperature is achieved.
The "Heat" indicator
lights up when heating. It flashes when there is a request for more heat. Once set
temperature is reached the indicator shuts off, on the 230 volt models only the low speed of the jet pump
turns off after 30 seconds (if not in filter cycle).
JETS OPERATION
230 volt models: Firmly press the Jets (1) button once to activate the low speed of the pump and again
for the high speed. Firmly press the Jets (1) button again to turn off the pump. If left running the low or high
speed pump will automatically turn off after 1 hour. The "Jets" indicator light above the button will blink when
the jet pump is on low speed and is solid on high speed. On 2 pump models, press the Jets (2) button once
to activate jet pump 2 on high and press a second time to turn jet pump 2 off unless in a filter or heat cycle.
110 volt models: Press the Jets button once to turn on the pump and a second time to turn off the pump.
MULTI COLOR LED LIGHT
Press the Light button once to turn on the light, the light indicator next to the button is lit when the light is on.
Press the button again to turn the light off. Every time the light is quickly turned off and on a new light mode
will appear. The sequence is as follows: White, Full color wheel, Amber, Blue, Red, Green, Purple, color
wheel 1, color wheel 2 and abrupt color wheel. The last light mode used will come back on when the light is
turned off for more than 2 seconds.
NOTE: If left on, the light will automatically turn off after 4 hours of operation.
FILTER CYCLES
There are two filter cycles: the first cycle (F1) starts right after power up and the second cycle (F2) will start
12 hours later. The default duration for the first filter cycle is 1 hour, and 30 minutes for the second cycle.
Filter cycles (on 230 volt models) only run at low speed. The “Filter” indicator lights up when a filter cycle
is on. The duration of each filter cycle can be modified.
CONTROL PANEL OPERATION
Indicator Lights
Temp Down
Temp Up
Jets Light
1 Pump
Indicator Lights
Jets 1 Jets 2
Light
Temp Up/Down
2 Pump