Use and Care Manual

11
OPERATING INSTRUCTIONS
1. Turn the heater on or off by pressing the
Power button on the control panel (C) or by
pressing the ON/OFF button on the remote
control (B).
Once the power is off, heating elements
will stop working first. The fan will continue
working for up to 90 seconds to dispense
residual heat inside the heater. This is a
normal function.
1
C B
2. Select a heat setting by pressing the MODE
button on either the control panel (C) or the
remote control (B) to toggle between the
three heat settings and fan only mode.
Power for high mode is 1,500 W; low is 1,000
W. ECO mode is an economic energy saving
function. When ECO mode is chosen, the
heater will operate to maintain a constant
warm 68°F.
Note: The ECO LED light will only illuminate
when the ECO function is active and the
ambient room temperature falls below
68ºF / 20ºC.
2
HIGH LOWECO
UV
C
B
3. Set the temperature by pressing the arrows on
the control panel (C) or the remote control (B).
You can set the temperature on the heater
anywhere between 50°F and 90°F or between
10°C and 32°C. Once you have chosen the
desired temperature, the heater will remain
on until the room temperature increases to
the temperature on the digital display. The
heater will cycle on and off to maintain the
desired room temperature.
To view the ambient temperature short press
the ambient temperature button on the
control panel (C) or remote control (B).
Note: To switch between Fahrenheit and
Celsius, press and hold the ambient
temperature button on the control panel
(C) for 5 seconds.
Note: To engage the child lock on the remote
(B), press and hold for 3 seconds.
Deactivate the lock by repeating these
steps.
3
C
B
C
B
OR