INFRARED QUARTZ HEATER MODEL #LS21-2W-BPIQT lifepro® is a registered trademark of lifecorp products®, All Rights Reserved. ATTACH YOUR RECEIPT HERE Purchase Date ____________Serial Number (located on back of unit) __________________ Questions, problems, missing parts? Contact technical support department at 1-866-484-2066, 8:00 a.m. - 5 p.m., CST, Monday - Friday or www.@lifecorpproducts.
TABLE OF CONTENTS Package Contents. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Frequently Asked Questions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Preparation. . . . . . . . . . . . . . . . . . . . . . . . . . . .
PACKAGE CONTENTS A B C D Front View PART A B C D Rear View DESCRIPTION Infrared Heater Master Power Switch (pre assembled to Infrared Heater (A)) Control Panel (pre assembled to Infrared Heater (A)) Filter Cover (pre assembled to Infrared Heater (A)) 3 QUANTITY 1 1 1 1
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate, or install the product. IMPORTANT SAFETY INSTRUCTIONS WARNING: POTENTIAL ELECTRICAL HAZARD IF NOT ADHERED TO. When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: • This heater must be plugged into a 120 V, 15 amp (or more) circuit of its own.
SAFETY INFORMATION Tip-Over Safety Feature This heater is equipped with a tip-over safety feature. Once the heater is tipped over, an internal switch will automatically shut the heater off. Once the heater is restored to an upright position, the heater will reset. To continue operation, turn on the heater using the supplied remote control or the control panel on the heater. Overheat Safety Feature This heater is equipped with an overheat safety feature.
FREQUENTLY ASKED QUESTIONS Please review these frequently asked questions on the next few pages prior to using your heater. Q. My heater emits a strange odor when I first open the box and when I turn the heater on for the first time. Why is this happening? A. This is normal. This heater is treated with a special heat safe/resistant coating. This odor will sometimes be present when the box is opened.
FREQUENTLY ASKED QUESTIONS Q. Can I use more than one heater at a time? Can I use the heater and another appliance at the same time? A. Yes, but make sure they are not plugged into the same circuit. Each heater requires its own minimum 15-amp circuit with no other items plugged into that circuit or outlet. This is because heaters are considered appliances and draw out high amperage. If you are unsure whether your circuit meets these requirements, verify with a certified electrician.
PREPARATION Place the heater on a firm, level surface and plug into a grounded 120 V, 60 Hz power outlet. Only operate heater in upright position. Please note that infrared heaters do not heat like a traditional space heater. You should not expect infrared heaters to blow hot air like a traditional space heater. Infrared heaters heat objects not air. Infrared heaters are intended to supplement an already heated, insulated room. Square footage specifications assume a single enclosed room not an entire home.
CONTROL PANEL 1 PART 1 2 3 2 NAME Thermostat Dial Digital Display Mode Dial 3 DESCRIPTION Increases and decreases desired temperature Readout of ambient room temperature Toggles between Off / Fan / Low / High Modes 9
OPERATING INSTRUCTIONS 1. Turn the heater on or off by turning the MODE dial on the control panel (C) to the 1 position. 1 Once the power is off, the heating elements and fan will stop working. This is a normal function. C 2. Select a heat setting by turning the MODE dial on the control panel (C) to the 1, 2 or fan only position. 2 Power for setting 1 mode is 1,000 W; setting 2 mode is 1,500 W. FAN mode is an cooling function. When FAN mode is chosen, the heater will operate at approximately 15 W.
CARE AND MAINTENANCE WARNING: Before performing any maintenance task, unplug the unit, and allow it to cool completely. 1. To keep the heater clean, clean the outer shell with a soft, damp cloth. Use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth. CAUTION: DO NOT let liquid enter the heater. 2. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This may cause damage or deterioration to the surface of the heater. 3.
ONE-YEAR LIMITED WARRANTY The manufacturer warrants this heater against defects in materials and workmanship on functional parts, for a period of 1 year from the original date of purchase. Your sales receipt showing the date of purchase of the product is your proof of purchase. Keep it in a safe place for future reference. This product is made with the highest quality materials and is warranted to be free from defects in materials and workmanship at the time of purchase.
REPLACEMENT PARTS LIST For replacement parts, call our technical support department at 1-866-484-2066, 8 a.m. - 5 p.m., CST, Monday - Friday PART DESCRIPTION A Mode Switch B Fan PART # MO-SW FAN213 C Thermostat D Tip-Over Switch E Limit Switch F Infrared Tube QUAR-R21 G Temp Sensor SENSOR H Power Switch MAINSW-S A THER-SW B TIPSW C LIMIT110 D E F G H PLEASE REMEMBER TO REGISTER YOUR WARRANTY: Registration@lifecorpproducts.
