Manualshelf

Use and Care Manual

ManualsBrandsLifesmart ManualsHeating, Ventilation, and Air ConditioningIndoor/Outdoor 700 CFM 3 Speed Dual Port Portable Evaporative Cooler for 500 sq. ft.
123456789
Rev. 1/15 5
SPACE COOLER OPERATION
Cooling ON
1. Open and fill water tank (use clean water only) to the bottom of the fill basket. DO NOT OVER FILL,
then replace water cap. (Important: Fully tighten tank cap to ensure proper cooling function)(fig. 1).
Overfilling could cause water streaming during shutdown.
2. Plug the power supply DC Jack into the power port on the unit (fig. 2).
3. Plug the power supply into a GFCI prote
cted 120v 60Hz rated outlet. (fig. 3).
4. Press the power button to turn on the product (fig 4). The fan speed will start on low speed.
5. Press the fan button incrementally to increase the fan speed (low, med, high) (fig 5).
6. Turn on the cooling function by pressing the cooling button (fig 6).
Cooling OFF
1. The cooling function can be turned off by pressing the cooling button (fig. 6).
2. Pres
sing the power button will turn off all functions. (fig. 4).
Note: The space cooler will continue to atomize for a short time while the unit depressurizes
ADJUSTING COMFORT LEVEL
CAUTION: Do not over tighten and/or loosen the cooling dial.
The cooling function of this product is adjusted by turning the cooling dial on the space cooler control panel to
the right or to the left. It may take a minute for cooling to start. It is n
ormal for air to come out of the nozzles
before the cooling begins.
To optimize the cooling effectiveness of your space cooler, you can operate the unit with low or high
atomization, based on your comfort preference.
Increase the density by turning the cooling dial to the left.
Decrease the density by turning the cooling dial to the right.
Operating Tips
For dry climates, increasing the cooling density will provide maximum cooling results. In humid climates, a
reduced cooling density is recommended.
7. Fully close the Cooling Dial by turning to the right. DO NOT OVER TIGHTEN COOLING
DIAL, DAMAGE TO THE UNIT MAY OCCUR. Allow up to 1 minute for priming.
8. Initiate water flow to the atomizer(s) by turning the Cooling Dial to the left 1 full turn.
9. Once atomization is visible, you can reduce the volume of water atomized by turning the
Cooling Dial to the right. (Refer to ADJUSTING COMFORT LEVEL section to achieve optimal
cooling performance of your space cooler. For Indoor Use: the atomized water should feel dry to
the touch 18” away from the nozzle).
10. The cooling port(s) can be rotated up to 90º from center in the left or right directions
(fig. 7)
.
11. The cooling port(s) can be tilted up to 30º from center vertically (fig. 8).