Instructions / Assembly

8
OPERATING INSTRUCTIONS
CUSTOMER NOTICE: To perform a leak test of your gas connections, mix a 50/50 solution of soap and
water and brush around regulator and other gas connections. If growing bubbles appear, there is a
leak. Re-tighten connections. If leaks cannot be stopped do not try to repair.
Lighting the Griddle
Do not lean over the griddle while lighting. Read
instructions before lighting.
3. Read all instructions before lighting.
4. Push the control knob to start the gas flow
5. Turn the control knob counter-clockwise
to activate the starter.
6. Adjust the temperature to desired level.
7. If ignition does not occur, turn gas off by
turning the knob clockwise and repeat
lighting instructions.
Match lighting Instructions
Do not lean over the griddle while lighting. Read
instructions before lighting.
1. Ensure the control knob is in the “OFF”
position.
2. Remove the griddle top.
3. Light an 11” long match, then place the
match on the right or left side of the burn-
er.
4. Push in and turn the control knob to the
HIGH position. Be sure burner lights and
stays lit.
Control Knob
Ignition Needle Placement
The ignition needle should be 3-7 millimeters
from the burner tube to create the proper spark.
The ignition needle should not touch the burner
tube.
Disconnecting the LP Bottle
Make sure your griddle is off and cool. Discon-
nect the regulator from the gas line by unscrew-
ing the collar, then unscrew the LP bottle from
the regulator.
WARNING: Turn controls and gas source or tank OFF when not in use.
CAUTION: If ignition does NOT occur in 5 seconds, turn the burner controls OFF, wait 5 minutes and
repeat the lighting procedure. If the burner does not ignite with burner and could accidentally ignite
with risk of injury.