Full Product Manual

12
Initial start-up - When the spa is first powered up, the control system begins a 2 minute Startup
Mode. Different codes will display on the screen. Once Startup Mode completes, the actual
temperature is displayed on the screen. The spa will then begin to heat and maintain the water
temperature and the first filter cycle
will start. Your spa has been designed
so that it will automatically heat the
water to the factory set temperature
of 100°F unless you set the spa to
a different temperature. If power is
disconnected from the spa, it will
automatically revert back to the last
saved set temperature when power is
reapplied.
TEMPERATURE ADJUSTMENT (80°F-104°F/26.5°C-40°C)
The temperature can only function between 80°F - 104°F / 26.5°C - 40°C. The last measured
temperature will constantly display on LCD.
Press the Plus or Minus buttons to display the set temperature and indicator
. Each time either
button is pressed again, the set temperature will increase or decrease depending on which button
is pressed. After five seconds, the LCD will automatically display the current spa temperature.
The "Heat" indicator lights up when heating. It flashes when there is a request for more heat. Once
set temperature is reached the indicator shuts off, on the LS550 Plus & LS600DX/Coronado HD
models only the low speed of the jet pump turns off after 30 seconds (if not in filter cycle).
JETS OPERATION
For LS550 Plus & LS600DX/Coronado HD models, firmly press the Jets button once to activate the
low speed of the pump and again for the high speed. Firmly press the Jets button again to turn off
the pump. If left running the low or high speed pump will automatically turn off after 1 hour. The "Jets"
indicator light next to the button will blink when jet pump is on low speed and is solid on high speed.
For all other models, press the Jets button once to turn on the pump and a second time to turn off the
pump .
MULTI COLOR LED LIGHT
Press the Light button once to turn on the light, the light indicator next to the button is lit when the
light is on. Press the button again to turn the light off. Every time the light is quickly turned off and
on a new light mode will appear. The sequence is as follows: White, Full color wheel, Amber, Blue,
Red, Green, Purple, color wheel 1, color wheel 2 and abrupt color wheel. The last light mode used
will come back on when the light is turned off for more than 2 seconds.
NOTE: If left on, the light will automatically turn off after 4 hours of operation.
FILTER CYCLES
There are two filter cycles: the first cycle (F1) starts right after power up and the second cycle (F2)
will start 12 hours later. The default duration for the first filter cycle is 1 hour, and 30 minutes for
the second cycle. Filter cycles (on LS550 Plus & LS600DX/Coronado HD models) only run at low
speed. The “Filter” indicator lights up when a filter cycle is on. The duration of each filter cycle
can be modified.
CONTROL PANEL OPERATION
Jets Light
Indicator Lights
Temp
Minus
Temp
Plus