Full Product Manual

13
CONTROL PANEL OPERATION
ADJUSTING PRESET FILTER CYCLES
Filter duration is programmable between 0.5 and 6 hours in 30 minute increments (0.5 hours) for
both filter cycles. To program the cycle times:
1. Press and hold Light button for 5 seconds until F1 is displayed.
2. Press the Plus or Minus button to adjust the cycle time for F1.
3. Press the Light button to store the F1 cycle and move to the F2 cycle.
4. Press the Plus or Minus button to adjust the cycle time for F2.
5. Wait 15 seconds to allow the exit timer to expire and store the setting.
IMPORTANT: To reset the first filter cycle start time, skip step 5 and continue pressing the Light
button until the actual temperature is displayed. Powering down of the spa will also reset the first
filter start time.
FILTER CYCLE SUSPENSION: The filter cycle will be suspended every time a jet pump or
light is activated manually during the filter cycle time. The suspension will end 10 minutes after the
completion of the manual use.
OPERATIONAL MODES
The Standard Mode is the default operational mode preset from the factory.
STANDARD MODE: Is programmed to maintain the desired temperature with periodic water
circulation (sampling) to sample and heat the water to the set temperature.
The Following Three Modes are only used with LS550 Plus & LS600DX/CORONDO HD MODELS
ECONOMY MODE This will reduce the set temperature of the spa by 20°F. Water sampling
and heating of the water is only done during the filter cycles.
SLEEP MODE: Water sampling and heating is only done during the filter cycles while trying to
bring the spa water up to the set temperature.
QUIET MODE: Maintains temperature with periodic sampling between the start of F1 and the
end of F2 while not allowing any water sampling to happen between the end of F2 and the start of F1.
To enter the programming screen and toggle between Standard, Economy, Sleep and Quiet
Modes the following is required:
1. Press and hold the Light button for 5 seconds.
2. Press the Light button several times until St, Ec, SL, or nt is displayed.
3. Use the Plus or Minus button to choose between the Modes.
St = Standard Mode, Ec = Economy Mode, SL Sleep = Mode and nt = Quiet Mode.
4. Wait 15 seconds to allow the exit timer to expire and store the setting.
OFF MODE: This mode allows you to stop all spa functions for 30 minutes to perform quick
spa maintenance To place the spa in OFF MODE, press and hold the Jets button for 5 seconds.
The display will toggle between OFF and water temperature when in the OFF MODE. To stop the
OFF MODE before the 30 minute cycle time is complete, simply tap (short press) the Jet button.
FAHRENHEIT/CELSIUS SETTING
To change water temperature display to either Fahrenheit or Celsius, press and hold Light
button for 5 seconds until F1 is displayed. Press the Light button several times until F or C is
displayed. Press the Plus or Minus button to change. Wait 15 seconds to allow the exit timer to
expire and store the setting.