Instructions / Assembly

12
INITIAL START-UP - When the spa is first powered up the control system begins a 2 minute
Startup Mode. Different codes will display on the screen. Once Startup Mode completes, the
actual temperature is displayed on
the screen, and the spa will then
begin to heat and maintain the
water temperature and the first filter
cycle will start. Your spa has been
designed so that it will automatically
heat the water to the factory set
temperature of 100°F unless you set
the spa to a different temperature. If
power is disconnected from the spa,
it will automatically revert back to the
last saved set temperature when power is reapplied.
TEMPERATURE ADJUSTMENT (80°F-104°F/26°C-40°C)
The temperature can only function between 80°F - 104°F / 26°C - 40°C. The last measured tem-
perature will constantly display on LCD.
Press the Plus or Minus buttons to display the set temperature and indicator . Each time either
button is pressed again, the set temperature will increase or decrease depending on which button
is pressed. After five seconds, the LCD will automatically display the current spa temperature.
The “heater” indicator lights up when the heater is on. It flashes when there is a request for
more heat, but the heater is not on. Once set temperature is reached the indicator shuts off and
the low speed of the jet pump turns off after 30 seconds (if not in filter cycle).
JETS OPERATION
For CORONADO model, firmly press the Jets button once to activate the low speed of the pump
and again for the high speed. Firmly press the Jets button again to turn off the pump. If left
running the low or high speed pump will automatically turn off after 1 hour. The "Jets" indicator
light next to the button will blink when jet pump is on low speed and is solid on high speed. For all
other models, press the Jets button once to turn on the pump and a second time to turn off the pump.
MULTI COLOR LED LIGHT
Press the Light button once to turn on the light, the light indicator next to the button is lit when the
light is on. Press the button again to turn the light off. Every time the light is quickly turned off and on
a new light mode will appear. The sequence is as follows: White, Slow Full color wheel, Amber, Blue,
Red, Green, Purple, Blue/Green color wheel, Red/Green color wheel and Fast Full color wheel. The
last light mode used will come back on when the light is turned off for more than 2 seconds.
NOTE: If left on, the light will automatically turn off after 4 hours of operation.
FILTER CYCLES
There are two filter cycles: the first cycle (F1) starts right after power up and the second cycle (F2)
will start 12 hours later. The default duration for the first filter cycle is 1 hour, and 30 minutes for
the second cycle. Filter cycles (on Coronado model) only run at low speed. The “Filter” indicator
lights up when a filter cycle is on. The duration of each filter cycle can be modified.
CONTROL PANEL OPERATION
Jets Light
Indicator Lights
Temp
Minus
Temp
Plus