Manual

ASSEMBLY
CAUTION: Carefully read end follow step I below before removing the restraining tie. If the restraining tie.
is removed prematurely, serious bodily Injury may result. Assembly requires two people. Set the beadmlll in"
a cleared area and mrnove the packing materials, except for the restraining tie. Do not dispose of the packing
reatedals unfilassembly is completed. Assembly requires the Included allen wrench] and a phillips screw-
driver ,.======C:_:) (not included).
1. Slide the Left Upright (f) onto the left side of the Base
(55). It may be necessary to firmly push down on the
Left Upright until it Is fully seated on the Base.
Remove the restraining tie from the Base (55).
Usingtheallenwrench,tightentwo of thefourUpright
Screws(50) intothe LeftUpright(f) and theBase(55).
50
55
Restraining Tie
2. Slide the Right UPdght (43) onto the right side of the Base
(55). It may be necessary to firmly push down on the
Right Upright until it is fully seated on the Base. Be
careful not to pinch the Wire Harness (19) between
the Right Upright and the Base.
Using the allen wrench, tighten two Uprigbt Screws (.50)
intothe Right Upright (43) and the Base (55).
Remove the wire ties (not shown) attaching the Console
Base (g) to the Right Upright (43).
3. Set the Console Base (9) on the Left and Right Updghla
(1, 43).
While one person carefully feeds any slack Wire Harness
(19) down into the Right Upright (43), a second person
should carefully pull the slack Wire Hamess from the
lower end of the Right Upright.
/
Attach the Console Base (9) with four Console
Screws (7).
7
5