Instructions / Assembly

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
13
SEC
2
SEC
2.5
SEC
2.6
Insert the two (2) 1/4”-20 x 5 1/2” Carriage Bolts (AZW) through the holes in the Split Collar and out through the Base
Plate.
With the holes in the tabs of the Base aligned with the holes in the Pole Assembly, secure the Base Plate to the
Pole Assembly with two (2) 1/4”-20 Nylock Nuts (AZP). Tighten Nuts securely, but do not overtighten.
AZP
AZP
AZW
AZW
Note: You will need to align the holes in the Split Collar with the
holes in the Base Plate.
!
AZW (x2)
(Not To Scale)
5 1/2”
AZP (x2)
7/16”
WARNING
Do not place the system in an upright position until
instructed. The system may fall over and could result in
serious personal injury or property damage.