Instructions / Assembly

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
19
SEC
!
2
4FDVSFUIF)BOEMF"TTFNCMZUPUIF)BOEMF#SBDLFUTVTJOHUIFIBSEXBSFTIPXOJOUIFTFUPGIPMFTBUUIFFOEPG
UIF)BOEMF#SBDLFUT.BLFTVSFUIF1/2” Plastic Washers (AEG)BSFQMBDFECFUXFFOUIF)BOEMF#SBDLFUTBOEUIF
)BOEMF"TTFNCMZ
SEC
2.3
CYF
AEG
AEG
CYD
AEGY
CYFY
CYDY
8 5/8”
OPUBDUVBMMFOHUI
3/4"
3/8"
Note: DO NOT overtighten the hardware.
3FNPWFBMMQBDLBHJOHGSPNUIFGas Springs (AJR)4MJEFUIFGas Spring Cover (AKG)POUPUIF(BT4QSJOHBTJMMVTUSBUFE
MJOJOHVQUIFIPMFTJOUIF(BT4QSJOH$PWFSXJUIUIPTFJOUIFOBSSPXFOEPGUIF(BT4QSJOHRepeat this step for the
remaining Gas Spring and Gas Spring Cover.
SEC
2.4
1
2
Note: The Gas Spring Cover will rest loosely on the Gas Spring.
It will be secured to the Gas Spring later in the assembly.
!
AKG
AJR
Note: To simplify the upcoming steps, it may be helpful to fully extend the Gas Springs. To do so, carefully tap the small
release pin at the larger end of the Gas Spring with a Bolt. Continue tapping repeatedly until the Gas Spring is fully extended.
!
!
Note: Coat the 1/2” x 8 5/8” Bolt (CYD) lightly with Dark
Lithium Grease (AJZ) before performing this step.