user manual

51
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
SEC
SEC
ADKX
AEEX
3/8”
ADK
ADK
ADK
ADK
ADK
AEE
AEE
AEE
AEE
AEE
Interior View
Secure the Domed Skylight to the Roof Panel for Domed Skylight with one (1) #10 x 1/2” Flat Washer (AEE) and one
(1) #10 Cap Nut (ADK) for each Carriage Bolt. Set Skylight/Panel Assembly aside. Repeat this section for the second
Roof Panel for Domed Skylight.
ACRX
SEC
Neck of Carriage Bolt
Exterior View
Top
Insert one #10 x 5/8” Carriage Bolt (ACR) through each hole in the Domed Skylight. Press the Bolt through the
Butyl Tape and through the Roof Panel for Domed Skylight. The necks of the Carriage Bolts fi t into the square
holes in the Domed Skylight.
WARNING
Do not overtighten the Cap Nut. If the end of
the Bolt breaks through the plastic cap, call our
Customer Service Department. Exposed threads
on the end of the Bolt may cause serious injuries.
8.5
8.6
8