Installation Guide

4. Installation

Caution

• Do not pull or lift the product by the supply cable.

• The product must be accessible for maintenance and repair.

• The product must be placed in a frost- free room to prevent the pumped liquid from

freezing. Make sure that all external pipework is adequately insulated.

Note

• The discharge pipe must be made of rigid material, such as copper, or of rigid PVC with solvent-welded joints.

• To prevent the transmission of vibrations to buildings, make sure that the pipework is thoroughly fixed and

that fittings cannot move and are not in contact with building parts.

• An alarm device for acoustic alarm in case of malfunction or high level in the tank is available as an accessory

(noise level 75 dB(A).

• Extension pipes between the toilet and lifting station must not be longer than 5 ½” due to the increased

risk of clogging.

5. Electrical Connection

Make sure that the product is suitable for the supply voltage and frequency available at the installation site.

The electrical connection must be carried out in accordance with local regulations.

Warning

• The product must be earthed.

• The installation must include an earth leakage circuit breaker for protection against earth fault currents. This

ensures protection when using a Schuko plug or another plug with earth pin.

• The product must be connected to a main switch with a minimum contact gap of 3 mm in all poles. In case of

over heating, a thermal switch cuts out the motor and cuts it in automatically when it has cooled sufficiently.

6. Service

Warning

• The product must only be serviced by trained service personnel.

• If the supply cable is damaged, it must replaced by the manufacturer, the manufacturer’s service partner, or

a similarly qualified person.

• To ensure safe and reliable operation, always use original spare parts from the manufacturer.

• The product must be thoroughly cleaned before it is returned for service, otherwise the warranty will be void.

6.1 Maintenance

The lifting station does not require any special maintenance, but we recommend that you check operation and

pipe connections at least once a year. Change the carbon filter once a year. See section 6.2 Service instructions.