Installation Guide

ANLEY

STANLEY

A B C

D E F

TOOLS REQUIRED (NOT INCLUDED)

GUIDE TO MOUNTING THE CABINET ON THE WALL

MEASURE FROM THE EDGE

OF THE FLOOR UP.

MARK A HORIZONTAL LINE

WITH THE LEVEL AS A GUIDE TO

INSTALL THE MOUNTING PLATE.

WITH THE STUD FINDER LOCATE THE

STUDS AND MARK THEM WITH AN X,

THEN MARK A LINE IN THE CENTER

OF THE DRAINAGE.

DRILL A MOUNTING HOLE IN THE

INTERSECTION OF THE TWO LINES.

INSERT THE DRYWALL ANCHOR USING

THE SCREWDRIVER.

INSERT THE SCREW INTO THE

DRYWALL ANCHOR.

WITH THE LEVEL OVER THE MOUNTING

PLATE MAKE SURE THAT THE PLATE IS

LEVEL ON BOTH SIDES.

INSERT THE OTHER ANCHORS DIRECTLY

INTO THE STUDS USING A DRILL WITH A

HEXAGONAL BIT.

WALL

28" - 28"

11/32

27/64

(Follow this guide if you are using the optional legs. Otherwise, install the mounting plate at your desired height)

ANLEY

DRILL

STUD FINDER

TAPE MEASURE

ATTACHING THE MOUNTING PLATE

LEVEL

SCREWDRIVER

SILICONEPENCIL

50200 - 14 of 16