User Guide

23 Programming
Doc 01-G0547
Rev D
Programming
01-G0610F13
Figure 21
Switch #1: Operator Programming
POLE #1: SINGLE/CLOSE BUTTON
ON = Close button only
OFF = Open/Close button
POLE #2: RIGHT HAND / LEFT HAND
ON = Left Hand (gate will open to the left)
OFF = Right Hand (gate will open to the right—inside of
fence looking out)
Figure 22
POLE #3: WARNING DEVICE
ON = Warning device will turn on 3 seconds before gate
starts to move in either direction.
OFF = Warning device disabled.
POLE #4: MASTER/SLAVE – SINGLE UNIT
ON = Master or Single Unit
OFF = Slave Unit
RED LED INFORMATION
Continuous ON = Unit is on a limit.
Blinking 1 flash per second = Normal operation (gate travel or midstop).
Blinking 2 flashes per second = Entrapment level 1 (operator reverse to limit).