CONTENTS Important Safety Instructions ......... 2-3 PREMIUM Series Garage Door Opener Operation....................................4 Using the Door Control..................5 Programming-Door Control Panel ....6 Programming - Remote Controls ......7 ■ Please read this guide and the enclosed safety materials carefully! User’s Guide ■ The door WILL NOT CLOSE unless the Protector System is connected and properly aligned.
WARNING Important Safety Instructions Safety Symbol and Signal Word Review This garage door opener has been designed and tested to offer safe service provided it is installed, operated, maintained and tested in strict accordance with the instructions and warnings contained in this manual. When you see these Safety Symbols and Signal Words on the following pages, they will alert you to the possibility of serious injury or death if you do not comply with the warnings that accompany them.
WARNING Important Safety Instructions IMPORTANT SAFETY INSTRUCTIONS WARNING To reduce the risk of SEVERE INJURY or DEATH: 1. READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS. 2. ALWAYS keep remote controls out of reach of children. NEVER permit children to operate or play with garage door control push buttons or remote controls. 3. ONLY activate garage door when it can be seen clearly, it is properly adjusted, and there are no obstructions to door travel. 4.
Operation Your garage door opener is equipped with features to provide you with greater control over your garage door operation. Accessories provided with your garage door opener will vary depending on the garage door opener model purchased. if you hold the button on the door control or keyless entry until the door is fully closed. The safety reversing sensors do not affect the opening cycle. ALERT2CLOSE For energy efficiency the garage door opener will enter sleep mode when the door is fully closed.
Operation Using the Door Control PUSH BAR Press the push bar to open and close the door. SYNCHRONIZE THE DOOR CONTROL LIGHT BUTTON To synchronize the door control to the garage door opener, press the push bar until the garage door opener activates (it may take up to 3 presses). Test the door control by pressing the push bar, each press of the push bar will activate the garage door opener. Press the LIGHT button to turn the garage door opener lights on or off.
Operation Programming MOTION-DETECTING CONTROL PANEL Motion Sensor Switch Features Lock NOTE: Your remote controls will NOT work when LOCK mode is active however your keyless entry will still allow access to your garage. Activate: Press and hold the LOCK button for 2 seconds. The command LED will flash as long as the lock feature is activated and your handheld remote control will not operate your door at this time. Deactivate: Press and hold the LOCK button again for 2 seconds.
Operation Programming - Remote Controls Your garage door opener has been programmed at the factory to operate with your remote control. Older LiftMaster remote controls are NOT compatible. Programming can be done through the door control or the Learn button on the garage door opener. To program additional remote controls refer to the instructions provided with the additional remote controls or visit www.liftmaster.com.
Operation To Open the Door Manually DISCONNECT THE TROLLEY 1 2 To prevent possible SERIOUS INJURY or DEATH from a falling garage door: • If possible, use emergency release handle to disengage trolley ONLY when garage door is CLOSED. Weak or broken springs or unbalanced door could result in an open door falling rapidly and/or unexpectedly. • NEVER use emergency release handle unless garage doorway is clear of persons and obstructions. • NEVER use handle to pull door open or closed.
Adjustment Introduction Without a properly installed safety reversal system, persons (particularly small children) could be SERIOUSLY INJURED or KILLED by a closing garage door. • Incorrect adjustment of garage door travel limits will interfere with proper operation of safety reversal system. • After ANY adjustments are made, the safety reversal system MUST be tested. Door MUST reverse on contact with 1-1/2" (3.8 cm) high object (or 2x4 laid flat) on floor.
Adjustment 1 Program the Travel Without a properly installed safety reversal system, persons (particularly small children) could be SERIOUSLY INJURED or KILLED by a closing garage door. • Incorrect adjustment of garage door travel limits will interfere with proper operation of safety reversal system. • After ANY adjustments are made, the safety reversal system MUST be tested. Door MUST reverse on contact with 1-1/2" (3.8 cm) high object (or 2x4 laid flat) on floor. 1.
Adjustment 2 Test the Safety Reversal System 2.1 Without a properly installed safety reversal system, persons (particularly small children) could be SERIOUSLY INJURED or KILLED by a closing garage door. • Safety reversal system MUST be tested every month. • After ANY adjustments are made, the safety reversal system MUST be tested. Door MUST reverse on contact with 1-1/2" high (3.8 cm) object (or 2x4 laid flat) on the floor. 3 2.2 With the door fully open, place a 1-1/2 inch (3.
Maintenance The Remote Control Battery EVERY MONTH • Manually operate door. If it is unbalanced or binding, call a trained door systems technician. • Check to be sure door opens and closes fully. Adjust if necessary, see page 10. • Test the safety reversal system. Adjust if necessary, see page 11. To prevent possible SERIOUS INJURY or DEATH: • NEVER allow small children near batteries. • If battery is swallowed, immediately notify doctor.
Troubleshooting Diagnostic Chart Your garage door opener is programmed with self-diagnostic capabilities. The UP and DOWN arrows on the garage door opener will flash the diagnostic codes. DIAGNOSTIC CODE SYMPTOM SOLUTION Up arrow Flash(es) Down arrow Flash(es) 1 1 The garage door opener will not close and the light bulbs flash. Safety sensors are not installed, connected, or wires may be cut. Inspect sensor wires for a disconnected or cut wire.
Troubleshooting Diagnostic Chart DIAGNOSTIC CODE SYMPTOM SOLUTION Up arrow Flash(es) Down arrow Flash(es) 4 1-4 4 5 Opener runs approximately 6-8", stops and reverses. Communication error to travel module. Check travel module connections, replace travel module if necessary. 4 6 The garage door opener will not close and the light bulbs flash. Door is moving stops or reverses. Manually open and close the door.
Repair Parts NOTE: For additional parts not shown, visit www.liftmaster.com to download or print the full owner’s manual. PART NUMBER DESCRIPTION 1 2 3A 3B 4A 4B 5 6 7 Light Lens Receiver Logic Board - Model 8360 Receiver Logic Board - Model 8355 Travel Module - Model 8360 Travel Module - Model 8355 Motor w/Travel Module - Model 8360 Motor w/Travel Module - Model 8355 3V2032 Lithium Battery (Remote Control) Backup Battery (if applicable) Safety Sensor Kit with receiving and sending sensors with 3 feet (.
Warranty LIFTMASTER® ONE YEAR LIMITED WARRANTY LIFETIME MOTOR AND BELT* LIMITED WARRANTY ONE YEAR LIMITED WARRANTY FOR THE BATTERY BACKUP SYSTEM* The Chamberlain Group, Inc.
MATIÈRES Importantes Consignes de Sécurité ......... 2-3 Ouvre-porte de garage de série PREMIUM Fonctionnement ...................................4 Utilisation de la commande de porte .......5 Programmation - Panneau de commande de porte............................6 Programmation - Télécommande............7 Guide de l’utilisateur POUR RÉSIDENCES SEULEMENT ■ Veuillez lire attentivement ce guide de même que la documentation de sécurité incluse.
Importantes Consignes de Sécurité Revue des symboles de sécurité et des mots de signalement Cet ouvre-porte de garage a été conçu et mis à l’essai dans le but d’offrir un service sûr à condition qu’il soit installé, utilisé, entretenu et mis à l’essai en stricte conformité avec les instructions et les avertissements contenus dans le présent manuel.
Importantes Consignes de Sécurité IMPORTANTES CONSIGNES DE SÉCURITÉ AVERTISSEMENT Pour réduire le risque de BLESSURES GRAVES, voire MORTELLES : 1. LIRE ET SUIVRE TOUS LES AVERTISSEMENTS ET INSTRUCTIONS. 2. Gardez EN TOUT TEMPS la télécommande hors de portée des enfants. Ne JAMAIS laisser les enfants faire fonctionner les télécommandes ou les boutonspoussoirs de la commande de porte ou jouer avec ceux-ci. 3.
Fonctionnement Votre porte de garage est dotée de fonctions qui vous offrent un meilleur contrôle du fonctionnement de votre porte de garage. Les accessoires fournis avec votre ouvre-porte de garage peuvent varier selon le modèle acheté. CONSERVATION DE L’ÉNERGIE Pour une efficacité énergétique, l’ouvre-porte de garage se met en mode de veille lorsque la porte est complètement fermée. Le mode de veille ferme l’ouvre-porte de garage jusqu’à ce qu’il soit activé.
Fonctionnement Utilisation de la commande de porte BARRE DE POUSSÉE SYNCHRONISATION DE LA COMMANDE DE PORTE Appuyez sur la touche-poussoir pour ouvrir ou fermer la porte. Pour synchroniser la commande de porte et l’ouvre-porte de garage, appuyez sur la barre-poussoir jusqu’à ce que l’ouvre-porte de garage s’active (cela peut prendre jusqu’à 3 pressions). Vérifiez la commande de la porte en appuyant sur la barre-poussoir, chaque pression sur la barre-poussoir activera l’ouvre-porte de garage.
Fonctionnement Programmer PANNEAU DE COMMANDE DE DÉTECTEUR DE MOUVEMENT Interrupteur de Témoin détecteur de d’entretien DEL mouvement Bouton « LEARN » Fonctions Verrouillage REMARQUE : Vos télécommandes ne fonctionnent PAS lorsque le mode de verrouillage « LOCK » est actif; toutefois, la fonction d’entrée sans clé vous permet quand même d’accéder à votre garage. Pour activer : Maintenez le bouton « LOCK » enfoncé pendant deux secondes.
Fonctionnement Programmation - Télécommande L’ouvre-porte de garage a été programmé en usine de manière à fonctionner avec la télécommande fournie. Les anciens télécommandes LiftMaster NE son pas compatibles. La programmation peut être réalisée par le biais de la commande de porte ou du bouton d’apprentissage de l’ouvre-porte de garage. Pour programmer des télécommandes supplémentaires, se reporter aux instructions fournies avec les télécommandes supplémentaires ou consulter le site www.liftmaster.com.
Fonctionnement Ouverture manuelle de la porte DÉGAGEMENT DU CHARIOT 1 2 AVERTISSEMENT Pour prévenir d’éventuelles BLESSURES GRAVES ou LA MORT par suite de la chute d’une porte de garage : • Si possible, utilisez la poignée de déclenchement d’urgence pour dégager le chariot UNIQUEMENT lorsque la porte de garage est FERMÉE. Des ressorts faibles ou brisés ou une porte déséquilibrée peuvent provoquer la chute rapide et/ou imprévue d’une porte ouverte.
Réglage Introduction AVERTISSEMENT Sans un système d’inversion de sécurité bien installé, des personnes (plus particulièrement les petits enfants) pourraient être GRIÈVEMENT BLESSÉES ou TUÉES par une porte de garage qui se referme. • Un réglage erroné des courses de la porte de garage gênera un fonctionnement approprié du système d’inversion de sécurité. • Après avoir effectué quelque réglage que ce soit, on DOIT faire l’essai du système d’inversion de sécurité.
Réglage 1 1.1 Programmation de la course Appuyer sur le bouton de réglage et le maintenir enfoncé jusqu’à ce que le bouton « UP » commence à clignoter ou qu’un bip se fait entendre.
Réglage 2 Essai du système d’inversion de sécurité AVERTISSEMENT 2.1 Sans un système d’inversion de sécurité bien installé, des personnes (plus particulièrement les petits enfants) pourraient être GRIÈVEMENT BLESSÉES ou TUÉES par une porte de garage qui se referme. • On DOIT procéder à une vérification mensuelle du système d’inversion de sécurité. • Après avoir effectué quelque réglage que ce soit, on DOIT faire l’essai du système d’inversion de sécurité.
Entretien La pile de la télécommande CHAQUE MOIS • • • Faire fonctionner la porte à la main. Si elle est déséquilibrée ou si elle force, appeler un technicien formé en systèmes de porte. S’assurer que la porte s’ouvre et se ferme complètement. Ajuster, au besoin, voir page 10. Essai du système d’inversion de sécurité. Ajuster, au besoin, voir page 11. AVERTISSEMENT CHAQUE ANNÉE • • Pour éviter des BLESSURES GRAVES, VOIRE MORTELLES : • Ne laissez JAMAIS des enfants s’approcher de la pile.
Dépannage Fiche diagnostique Des fonctions d’autodiagnostic ont été programmées dans votre ouvre-porte de garage. Les flèches vers le haut et le bas de l’ouvre-porte de garage font clignoter les codes d’anomalie. CODE D’ANOMALIE La flèche vers le haut clignote La flèche vers le bas clignote 1 1 1 2 1 3 1 4 1 5 1 6 2 1-5 3 2 3 3 SYMPTÔME RÉSOLUTION L’ouvre-porte de garage ne ferme pas la porte et l’éclairage clignote.
Dépannage Fiche diagnostique CODE D’ANOMALIE La flèche vers le haut clignote La flèche vers le bas clignote 4 1-4 4 4 SYMPTÔME RÉSOLUTION Le mouvement de porte s’interrompt ou/et repart en direction inverse. Ouvrir et fermer manuellement la porte. Vérifier si un objet est collé ou obstrue la porte, comme un ressort ou une serrure brisé(e); corriger au besoin. Si la porte force ou colle, appeler un technicien formé en systèmes de porte.
Pièces de Rechange NUMÉRO DE LA PIÈCE DESCRIPTION REMARQUE : Pour les pièces supplémentaires non affichées, visitez www.liftmaster.com pour télécharger ou imprimer du plein le manuel propriétaire.
Garantie GARANTIE LIMITÉE À UN AN DE LIFTMASTER® GARANTIE LIMITÉE À VIE SUR LE MOTEUR ET LA COURROIE* GARANTIE LIMITÉE D’UN AN SUR LE SYSTÉME DE PILE DE SECOURS* Le Chamberlain Group, Inc.