Owners manual

INTRODUCTION

LOOPS

Entrapment protection devices are required to protect against any

entrapment or safety conditions encountered in your gate

application (refer to pages 20-21 for more details). Install warning

signs on both sides of the gate.

Gate must be constructed and installed according to ASTM F2200

standards (refer to page 4). Gate must fit specifications of operator

(refer to specifications).

(Inside Property)

Entrapment Danger

Warning Signs

SAFETY GATE

SITE PREPARATION

Check the national and local building codes BEFORE installation.

Trench and install conduit. Before trenching, contact underground

utility locating companies. Conduit must be UL approved for low

and high voltage.

TRENCH

Loops allow the gate to stay open when vehicles are obstructing the

gate path. Suggested for vehicles 14 feet (4.27 m) or longer. Loops

are not required but are recommended.

CHECK YOUR GATE

Gate MUST be level. Gate and gate

post MUST be plumb. Gate MUST

have a smooth bottom edge, no

protrusions should exist.

Remove ANY/ALL wheels

from the bottom of gate.

Gate MUST NOT hit or drag

across ground.

Gate MUST swing freely and

be supported entirely by its

hinges.

Conduit