Installation Guide
Installation.
Your Beam can be applied to metal, glass,
painted, stained or varnished wood, tile, painted
cinder block, plaster, and painted wallboard.
In all cases ensure that the surface is a flat,
clean, sealed and hard. Clean the surface
with isopropyl rubbing alcohol, gently wiping
and leave to dry. Do not use other cleaning
substances. To apply to the wall, remove the
back Command Strip™ liner, and push the
product firmly on the wall for 30 seconds, putting
pressure on each contact point.
3Stick Beam and hold
position for 30 seconds.
1Clean surface
with alcohol
wipe provided.
2Peel.
4Connect
to power.